FAG SS3469 Manual Transmission Input Shaft Repair Sleeve - Rear

Manual Transmission Repair Sleeve

FAG SS3469 is a manual transmission input shaft repair sleeve built to restore a worn shaft sealing surface. It is sized for specific shaft and flange dimensions, making it a fitment-based solution for applications that need a precise repair surface rather than a full shaft replacement.

Key Features

• Repair sleeve for manual transmission input shaft sealing surfaces
• Precision dimensions: 1.375 in shaft diameter, 1.638 in flange diameter
• Measured installation depth of 0.813 in for controlled placement
• Designed around application-specific transmission service requirements
• FAG SS3469 part number for catalog and service matching

Detailed Description

FAG SS3469 is intended for service work where the input shaft surface has wear, scoring, or seal damage that can affect sealing performance. The sleeve provides a new running surface for the seal and helps restore proper contact on the shaft without changing the entire component. With its defined width and shaft measurements, this repair sleeve supports accurate service on vehicles such as the Mazda 3, Mazda 6, Dodge Ram 1500, and Chevrolet Corvette where the listed fitment applies. The FAG SS3469 part number is useful when matching service parts across catalogs and repair references.

This part cross-references KWK99133 and 99133 for the same application.

What It Is Used For

• Worn input shaft sealing surfaces
• Seal leakage caused by shaft wear
• Scoring or groove damage on the sealing area
• Transmission service where a repair sleeve is preferred over shaft replacement

Installation Notes and Tips

Verify shaft diameter and installation depth before service. Clean the shaft thoroughly so the sleeve seats on a smooth surface, and confirm the repair sleeve aligns with the seal contact area during installation. Use the listed fitment to confirm application details for Mazda 2, Mazda 5, Saturn Astra, Dodge Ram 2500, Chevrolet Tahoe, and other listed vehicles before ordering.

Quality Assurance

FAG states that its seals are engineered to meet vehicle manufacturer specifications and quality standards through supplier collaboration. SS3469 follows the same application-focused approach, with dimensions and fitment data provided for accurate parts matching.