FAG SS3610 Automatic Transmission Oil Pump Seal - Front

Automatic Transmission Oil Pump Seal for Toyota

The FAG SS3610 is a transmission sealing component built with nitrile sealing material, a rubber spring design, and an auxiliary lip to help maintain a tight seal at the oil pump. With a 2.559 in bore diameter, 2.563 in outside diameter, and 1.693 in width, it is sized for specific Toyota applications that require precise sealing performance. This FAG SS3610 seal is listed for 1968-1974 Toyota Corolla front applications and 1967-1970 Toyota Corona applications.

Key Features

• Part number: SS3610
• Automatic transmission oil pump seal
• Sealing material: nitrile
• Seal type: rubber, spring, auxiliary lip
• Bore diameter: 2.559 in / 64.999 mm
• Outside diameter: 2.563 in / 65.1 mm
• Seal width: 1.693 in / 43.002 mm
• Fits select Toyota Corolla and Toyota Corona applications

Detailed Description

FAG SS3610 is a precision transmission seal designed around exact dimensional requirements for the oil pump area. The nitrile sealing material and auxiliary lip help maintain contact at the sealing surface, while the spring-loaded rubber construction supports consistent sealing under transmission operating conditions. This part number is a direct match for 1968-1974 Toyota Corolla front applications and 1967-1970 Toyota Corona applications, making it a focused choice for Toyota transmission service work where correct seal dimensions matter. If you are searching for a Toyota Corolla transmission oil pump seal or a Toyota Corona automatic transmission seal, SS3610 is the relevant FAG part number to verify against your original component.

This part cross-references National 470460 and SKF 550244 for the same application.

Common Problems It Can Address

• Transmission fluid leakage at the oil pump seal area
• Loss of sealing integrity from worn or hardened seal material
• Contamination entry around the transmission pump interface
• Fluid seepage during service after seal replacement
• Fitment issues caused by incorrect seal dimensions

Installation Notes and Tips

Confirm bore diameter, outside diameter, and width against the original seal before installation. Clean the sealing bore and mating surfaces thoroughly, and inspect the pump surface for wear or scoring that could affect sealing. Proper alignment during installation is important to avoid damaging the auxiliary lip or spring element. Verify vehicle application by year, model, and transmission configuration before ordering.

Quality Assurance

FAG designs seals using high-quality materials and application-specific specifications to meet vehicle manufacturer requirements. This SS3610 seal follows those dimensional and material standards for the listed Toyota Corolla and Toyota Corona applications.