FAG SS5037 Transfer Case Shift Shaft Repair Sleeve Kit

Transfer Case Shift Shaft Repair for GM SUVs

The FAG SS5037 transfer case shift shaft repair sleeve kit is built for service work on select GM SUVs with transfer case shift shaft wear. It uses a nitrile sealing material and is sized with a 0.75 in bore diameter, 0.75 in outside diameter, and 0.5 in seal width for the listed application.

Compatible with 2002-2006 Chevrolet Trailblazer and 2002-2006 GMC Envoy platforms, this FAG SS5037 kit supports transfer case service where shaft sealing surfaces need repair. It is also cross-referenced to SKF 480050 for the same application.

Key Features

• Transfer case shift shaft repair sleeve kit
• FAG part number SS5037
• Nitrile sealing material
• 0.75 in bore diameter
• 0.75 in seal outside diameter
• 0.5 in seal width
• Repair sleeve part number SS2114
• Seal part number SS2114

Detailed Description

FAG SS5037 is a transfer case shift shaft repair sleeve kit for service applications that require restoration of the sealing surface. The listed dimensions and nitrile construction support a precise repair on the specified GM vehicles, including Chevrolet Trailblazer and GMC Envoy models from 2002 through 2006. Use this kit when the transfer case shift shaft area shows wear that can affect sealing performance.

This part cross-references SKF 480050 for the same application. The FAG SS5037 designation should be verified against the vehicle and transfer case configuration before installation.

What It Helps Address

• Transfer case fluid seepage at the shift shaft area
• Wear on the sealing surface of the shift shaft
• Contamination entry from dirt, dust, and moisture
• Loss of grease or lubricant retention at the seal interface
• Service needs on 2002-2006 Chevrolet Trailblazer and GMC Envoy transfer cases

Installation Notes and Tips

• Confirm the transfer case shift shaft dimensions before installation.
• Inspect the shaft surface for scoring or corrosion before fitting the repair sleeve.
• Clean the sealing area thoroughly so the nitrile seal seats correctly.
• Verify the vehicle application by year, make, and model before ordering.
• Follow the transfer case service procedure for the specific vehicle and drivetrain configuration.

Quality Assurance

FAG designs seals to meet vehicle manufacturer specifications and works with suppliers to maintain its quality standards. The sealing design is intended to protect wheel-end and service components from contamination and help retain lubricant over the life of the bearing or service assembly.