FAG WR0115 Wheel Bearing Retaining Ring - Front or Rear

Wheel Bearing Retaining Ring for OE-Style Repair

The FAG WR0115 wheel bearing retaining ring is a chassis hardware component used to secure the wheel bearing assembly in place during service. Built for professional driveline and axle repair, it supports precise bearing retention on select Ford, Mazda, and Honda applications.

• Wheel bearing retaining ring for driveline and axle service
• Width: 0.098 in / 2.5 mm
• Outside diameter: 3.012 in / 76.5 mm
• OE-style hardware for bearing retention during repair
• Fits select Ford Fiesta, Ford Focus, Ford EcoSport, Ford Courier, Mazda 2, and Honda CR-V applications

Fitment Coverage

• Fits 2017 Ford Fiesta, rear
• Fits 2003-2016 Ford Fiesta, front
• Fits 1998-2001 Ford Fiesta, front
• Fits 2011-2014 Mazda 2, front
• Fits 2010-2013 Ford EcoSport, front
• Fits 2004-2008 Ford EcoSport, front
• Fits 2000-2011 Ford Focus, front
• Fits 2001-2010 Ford Courier, front
• Fits 2002-2006 Honda CR-V, rear

FAG WR0115 is engineered as a retaining clip for wheel bearing service where correct ring dimensions matter. The listed width and outside diameter help ensure the ring seats properly in the hub or bearing assembly, making it a practical choice for technicians replacing worn driveline hardware on Ford Fiesta and Ford Focus platforms, as well as Mazda 2 and Honda CR-V applications. This part cross-references SKF CIR63 and Timken RET63 for the same application.

Common Repair Uses

• Replacing a damaged or distorted wheel bearing retaining ring
• Restoring proper bearing retention after hub or axle service
• Addressing looseness caused by worn chassis hardware
• Supporting correct reassembly during front or rear wheel bearing work
• Matching OE-style dimensions for select Ford, Mazda, and Honda repairs

Installation Notes

Verify the ring dimensions against the original part before installation, especially the outside diameter and width. Clean the mating groove or seating surface thoroughly so the retaining ring can sit fully and evenly. Confirm the application position before assembly; this part is listed for front and rear use depending on vehicle fitment. Part number WR0115 should be matched to the vehicle’s bearing and hub configuration before final installation.

Quality Assurance

FAG supplies chassis-related service components for professional repair, including retaining clips, ABS cables, and bolts. WR0115 follows that OE-focused approach with application-specific sizing for select Ford Fiesta, Ford Focus, and related fitments.