FCS 1334415L Suspension Strut and Coil Spring Assembly - Front Left

Front Left Strut Assembly for Kia Telluride

The FCS 1334415L suspension strut and coil spring assembly is built for the front left position on 2020-2024 Kia Telluride models. With a compressed length of 14.96 inches, an extended length of 23.23 inches, and an 8.27-inch stroke, this assembly is specified to match the suspension travel needed for the application.

For buyers searching for a front left strut assembly for 2020-2024 Kia Telluride, FCS 1334415L provides a direct-fit suspension replacement option. The FCS line is focused on application-specific suspension components, and this part number is listed for the front left side only.

Key Features

• Part number: FCS 1334415L
• Part type: suspension strut and coil spring assembly
• Fits 2020-2024 Kia Telluride, front left
• Compressed length: 14.96 in.
• Extended length: 23.23 in.
• Stroke length: 8.27 in.
• Application-specific fitment for the Kia Telluride front suspension

Detailed Description

This FCS strut and coil spring assembly is engineered around the listed dimensions to align with the front left suspension geometry on the Kia Telluride. The compressed length, extended length, and stroke length are important measurements for maintaining proper suspension movement, ride height range, and wheel control in the specified application. If you are replacing a worn front left strut on a 2020, 2021, 2022, 2023, or 2024 Kia Telluride, FCS 1334415L is the cataloged match for that position.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Issues This Part May Address

• Front-end noise from a worn strut assembly
• Excessive bouncing or reduced damping at the front left corner
• Uneven ride height or suspension sag at the specified position
• Handling instability during braking, cornering, or road transitions
• Replacement needs after suspension wear on a Kia Telluride front left strut

Installation Notes and Tips

Verify the vehicle year, make, model, and front left position before installation. Compare the existing strut assembly dimensions to the listed compressed length, extended length, and stroke length to confirm the replacement matches the original suspension travel. Because this is a suspension strut and coil spring assembly, proper suspension service procedures and alignment checks should be followed after installation.

Quality Assurance

FCS catalogs this part for the specified Kia Telluride front left application, and the listed dimensions provide the key reference points for fitment verification. Part number FCS 1334415L is identified for 2020-2024 Kia Telluride models at the front left position.