FCS 84903 Hatch Lift Support - Left

FCS 84903 Left Shock for Corvette

The FCS 84903 is a left-side shock absorber application for 1984-1996 Chevrolet Corvette models. It is built around a 21.77-inch compressed length, 33.58-inch extended length, and 11.81-inch stroke to match the suspension travel requirements of the vehicle.

Key Features

• Compressed length: 21.77 inches
• Extended length: 33.58 inches
• Stroke length: 11.81 inches
• Left-side fitment for Chevrolet Corvette applications
• FCS part number 84903 for direct catalog identification

Fitment Details

• Fits 1984-1996 Chevrolet Corvette, left.

Product Overview

FCS 84903 is specified for the left side of the Chevrolet Corvette across the 1984-1996 model years. The listed compressed, extended, and stroke measurements are the key dimensions used to verify suspension geometry and travel before installation. For buyers searching for a left shock absorber for 1984-1996 Chevrolet Corvette, FCS 84903 provides the dimensional data needed to confirm application.

FCS is the brand line shown for this part, and this listing is identified by part number 84903. If you are cross-shopping suspension components for the same application, this part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Replacement Reasons

• Excessive bouncing or poor damping response
• Uneven ride control on the left side
• Suspension travel concerns tied to worn shock dimensions
• Noise or instability from a fatigued shock absorber

Installation Notes

Verify left-side placement and compare the compressed length, extended length, and stroke length against the original unit before installation. Confirm the vehicle is a 1984-1996 Chevrolet Corvette and inspect surrounding suspension components for wear that could affect ride quality or alignment.

Quality Assurance

Use the published dimensions and fitment data to confirm application accuracy for FCS 84903 before installation. This part is cataloged for the left side of the Chevrolet Corvette and should be matched to the vehicle’s suspension requirements using the listed measurements.