FCS 86381 Hatch Lift Support

FCS 86381 for Jeep Liberty Suspension Service

FCS 86381 is a gas-charged suspension component built around a 15.04-inch compressed length, 21.65-inch extended length, and 6.61-inch stroke length. Those dimensions are important for maintaining proper travel and fitment on the 2009-2013 Jeep Liberty, helping restore controlled suspension movement where the original part has worn.

Key Features

• Compressed length: 15.04 inches
• Extended length: 21.65 inches
• Stroke length: 6.61 inches
• Fits 2009-2013 Jeep Liberty
• FCS part number 86381 for direct application lookup

Detailed Description

FCS 86381 is specified for the 2009-2013 Jeep Liberty and is identified by its exact compressed, extended, and stroke measurements. These dimensions help ensure the suspension component operates within the intended travel range for the vehicle, supporting consistent ride control and suspension articulation. If you are searching for a Jeep Liberty suspension replacement by part number, FCS 86381 is the application-specific reference to verify before ordering.

FCS uses the same brand line designation as the brand name here, so this part is listed under the standard FCS product range rather than a separate sub-line. For buyers comparing Jeep Liberty suspension parts, the key fitment match is the 2009-2013 Jeep Liberty, and the part number 86381 should be used to confirm the correct application.

What This Part Helps Address

• Excessive suspension travel caused by a worn original component
• Poor control during compression and rebound movement
• Incorrect replacement length that can affect fitment
• Suspension noise related to degraded travel control
• Ride instability from an aging suspension unit

Installation Notes and Tips

Verify the compressed length, extended length, and stroke length against the removed part before installation. Confirm the vehicle is a 2009-2013 Jeep Liberty and match the application to FCS 86381 before beginning service. After installation, inspect surrounding suspension components for wear that could affect performance or alignment.

Quality Assurance

FCS parts are cataloged with application-specific dimensions to support accurate replacement selection. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.