FCS HS001 Suspension Ride Height Sensor - Front

Front Ride Height Sensor for Range Rover

The FCS HS001 suspension ride height sensor is a front-position replacement for select 2010-2012 Land Rover Range Rover models with VDS. It is built for vehicles that rely on accurate suspension height input to maintain proper ride control and leveling behavior.

Key Features

• Front suspension ride height sensor for select Range Rover applications
• Fits 2010-2012 Land Rover Range Rover, front, with VDS
• FCS HS001 part number for direct catalog identification
• Supports suspension height signal input used by the vehicle system
• Brand line: FCS suspension sensor replacement component

Detailed Description

FCS HS001 is a suspension ride height sensor made for the front position on 2010-2012 Land Rover Range Rover models equipped with VDS. This sensor helps the suspension system read vehicle height accurately so the control system can respond correctly to changing load and road conditions. If you are searching for a front ride height sensor for a 2010-2012 Land Rover Range Rover, HS001 is the cataloged match for that application.

This part cross-references Monroe Shocks & Struts (e.g., 172286) for the same application.

What It Helps Address

• Incorrect suspension height readings
• Warning lights related to ride height or suspension control
• Uneven vehicle stance at the front
• Poor suspension response from a faulty sensor signal
• Loss of proper height feedback to the suspension system

Installation Notes and Tips

Verify the vehicle is a 2010-2012 Land Rover Range Rover with VDS and confirm front-position fitment before ordering. Compare the original sensor connector, mounting points, and linkage orientation to the replacement part HS001. After installation, clear any stored suspension fault codes and perform the required system calibration or relearn procedure if the vehicle service information calls for it.

Quality Assurance

FCS HS001 is cataloged for the specified Range Rover application and front suspension position. Confirm fitment against the vehicle’s suspension configuration before installation.