Fel-Pro 60847 Fuel Injection Throttle Body Mounting Gasket

Fel-Pro 60847 Throttle Body Gasket

Fel-Pro 60847 is a premium fuel injection throttle body mounting gasket built for sealing the throttle body to the intake with application-specific materials. Its cork construction and precise dimensions support a reliable seal on Ford and Mazda applications where intake air control and fuel delivery depend on a tight mounting surface.

Key Features

• Premium cork material for throttle body mounting applications
• Inside diameter: 2.172 in. / 55.1 mm
• Outside diameter: 4.188 x 3.812 in.
• Thickness: 0.045 in. / 1.1 mm
• 4-bolt hole design for the listed applications
• Fel-Pro sealing technology focused on vehicle-specific fitment

Application Details

This Fel-Pro throttle body gasket is used on a wide range of Ford Ranger, Ford Mustang, Ford Thunderbird, Ford Aerostar, Mercury Cougar, Mercury Capri, Mazda B2300, and Mazda B2500 applications. Fits 1985-2001 Ford Ranger, N/A; Fits 1998-2001 Mazda B2500, N/A; Fits 1994-1997 Mazda B2300, N/A; Fits 1983-1993 Ford Mustang, N/A; Fits 1983-1988 Ford Thunderbird, N/A; Fits 1986-1987 Ford Aerostar, N/A; Fits 1984-1986 Mercury Cougar, N/A; Fits 1983-1984 Mercury Capri, N/A. Part number 60847 is also a direct reference point for buyers searching for a throttle body mounting gasket for these vehicles.

This part cross-references Fel-Pro 35380 and MAHLE G30942 for the same application.

Common Repair Uses

• Throttle body air leaks at the mounting flange
• Rough idle caused by a poor seal at the throttle body
• Vacuum leaks affecting fuel delivery and drivability
• Air bypass around the throttle body base
• Replacement during intake or throttle body service

Installation Notes

Clean both mating surfaces before installation and verify the throttle body flange is flat and free of old gasket material. Align the gasket carefully with the 4-bolt pattern and the 2.172-inch inside diameter opening before tightening fasteners to the vehicle manufacturer’s specification. For best sealing results, inspect the throttle body and intake surfaces for damage or warpage before reassembly.

Quality Assurance

Fel-Pro gaskets are built around application-specific sealing materials and vehicle-focused fitment to deliver dependable sealing performance. The 60847 gasket follows that approach for Ford and Mazda throttle body mounting applications, including Ford Ranger and Ford Mustang service needs.