Gates 12068 HVAC Heater Hose - Throttle Body Inlet

Gates 12068 Molded Heater Hose Overview

The Gates 12068 molded heater hose is an OEM-style coolant hose built for tight engine bays where a straight hose will not route correctly. It uses EPDM construction and a factory-molded shape to match the small inside diameter and curved routing needed at the throttle body inlet on select Mitsubishi applications.

Compatible with 2012-2013 Mitsubishi Lancer throttle body inlet applications, this molded heater hose supports coolant, water, and air transfer. It is also approved for marine use, making it a practical replacement when you need a formed hose that follows the original path without forcing or kinking.

Key Features

• Gates Molded Heater Hose, part number 12068
• Factory-molded, OE-style shape for compact engine compartments
• EPDM construction for coolant, water, and air service
• Small inside diameter: 10 mm (0.38 in) at both ends
• Centerline length: 150 mm (5.9 in)
• Fits 2012-2013 Mitsubishi Lancer throttle body inlet applications
• Approved for marine applications

Product Details

The Gates Molded Heater Hose line is built for vehicles that require a formed hose rather than a universal straight section. Part number 12068 follows the original routing used in tighter engine compartments, helping maintain proper hose alignment at the throttle body inlet. For shoppers searching for a 2012 Mitsubishi Lancer throttle body inlet hose or a 2013 Mitsubishi Lancer molded coolant hose, this part provides a direct-fit style solution based on the listed application.

This part cross-references Bosch 13068 for the same application.

Common Problems This Hose Can Address

• Cracked or hardened coolant hose material
• Improper routing caused by a straight replacement hose
• Coolant seepage at a worn throttle body inlet hose
• Kinking or collapse in a tight engine compartment
• Loss of hose flexibility from age and heat exposure

Installation Notes and Tips

• Verify the hose routing and end diameters before installation.
• Inspect adjoining fittings and clamps for wear, corrosion, or damage.
• Confirm the hose follows the original molded path to avoid stress at the connection points.
• Check coolant level and inspect for leaks after installation.

Quality Assurance

Gates is known for OE-style hose construction and application-specific molded designs. The 12068 molded heater hose is built to match the listed fitment and routing requirements for select Mitsubishi Lancer models.