Gates 19092 HVAC Heater Hose - Heater To Pipe-1

Gates Molded Heater Hose for Tight Engine Bays

The Gates 19092 molded heater hose is an OEM-style coolant hose built for smaller, tighter engine compartments where a straight hose will not route correctly. It is formed to match the factory path and is suitable for coolant, water, and air applications, with marine application approval.

Key Features

• Factory-molded design for a direct OE-style hose route
• EPDM construction for heater and coolant service
• 0.63 in. inside diameter at both ends
• 20.9 in. centerline length for the specified routing shape
• Compatible with coolant, water, and air applications
• Approved for marine applications
• Gates 19092 molded heater hose line for precise fitment

Product Details

Gates Molded Heater Hose 19092 is shaped to follow the original hose path in compact engine bays, helping maintain proper routing around nearby components. The molded EPDM construction supports heater circuit service where a formed hose is required, and the 16 mm end diameters match the listed application dimensions. This part cross-references BBB Industries (e.g., 11092, 19092) for the same application. It is a direct-fit option for Toyota Avalon, Toyota Camry, and Toyota Solara heater-to-pipe routing where the factory hose uses this molded configuration.

Vehicle Fitment

• Fits 1999-2004 Toyota Avalon, Heater To Pipe-1, Molded Heater Hose
• Fits 1997-2002 Toyota Camry, Heater To Pipe-1, Molded Heater Hose
• Fits 1999-2002 Toyota Solara, Heater To Pipe-1, Molded Heater Hose

Common Replacement Reasons

• Cracked or hardened heater hose material
• Coolant seepage at a formed hose section
• Poor routing from a previous incorrect hose shape
• Restricted heater flow caused by hose deterioration
• Need for an OE-style molded replacement on Toyota heater circuits

Installation Notes and Tips

Verify the hose path, end diameters, and centerline length against the removed part before installation. Confirm the heater-to-pipe routing on the vehicle and inspect adjoining pipes and clamps for wear or corrosion. Gates 19092 is intended for the listed molded application, so matching the original shape is important for proper clearance and fit.

Quality Assurance

Gates manufactures this molded heater hose as an OE-style replacement for factory routing requirements. The molded construction and EPDM material support consistent fitment for the listed Toyota applications.