Gates 19094 HVAC Heater Hose - Heater To Pipe-2

Gates Molded Heater Hose for Tight Engine Bays

The Gates Molded Heater Hose, part number 19094, is a factory-molded coolant hose built for compact engine compartments that need an OEM-style routing shape. It is made from EPDM and is approved for coolant, water, air, and marine applications.

Key Features

• Factory-molded design for precise hose routing
• EPDM construction for heater and coolant service
• End 1 inside diameter: 0.63 in. (16 mm)
• End 2 inside diameter: 0.63 in. (16 mm)
• Centerline length: 21.4 in. (544 mm)
• Compatible with coolant, water, and air applications
• Approved for marine applications

Product Details

Gates Molded Heater Hose 19094 is an OEM-style molded hose shaped to match the tighter packaging found in modern engine bays. Its 0.63-inch inside diameter at both ends and 21.4-inch centerline length make it a direct routing solution for heater and coolant plumbing where a straight hose would not follow the original path. This part cross-references Dayco 87859 for the same application.

Compatible With 1995-1999 Chrysler Sebring, Heater To Pipe-2; 1995-1999 Dodge Avenger, Heater To Pipe-2; and 1995-1999 Mitsubishi Eclipse, Heater To Pipe-2. The Gates 19094 molded heater hose is a practical replacement for vehicles that need the correct formed shape to maintain factory-style hose routing.

Common Replacement Uses

• Cracked or hardened heater hose
• Coolant leaks at a molded hose section
• Incorrect hose routing in a tight engine compartment
• Heat-related hose swelling or collapse
• Restoring heater circuit flow on Chrysler Sebring, Dodge Avenger, or Mitsubishi Eclipse applications

Installation Notes

Verify hose routing, end diameters, and centerline length before installation. Match the molded shape to the original heater-to-pipe path on the vehicle, and inspect adjoining pipes and clamps for wear or corrosion before reassembly. Confirm the hose is seated fully and routed without twist or contact with hot or moving components.

Quality Assurance

Gates manufactures this molded heater hose as an OE-style replacement built to the dimensional and material requirements needed for heater and coolant service. Part number 19094 is also listed under Carlson 19094 and Four Seasons 64112 for the same application.