Gates 19329 HVAC Heater Hose - Valve To Engine

Gates Molded Heater Hose for Honda Civic and Acura EL

The Gates 19329 molded heater hose is an OEM-style coolant hose built for tight engine compartments where a straight hose will not route correctly. Its factory-molded shape and EPDM construction support coolant, water, and air transfer, and it is approved for marine applications.

Key Features

• Factory-molded design for a precise OE-style route
• EPDM construction for heater and coolant service
• Small inside diameter: 0.63 in. (16 mm) at both ends
• Centerline length: 27.2 in. (691 mm)
• Compatible with coolant, water, and air applications
• Gates Molded Heater Hose line for tight-fit engine bay routing

Product Details

Gates 19329 is a molded heater hose made for vehicles with compact engine layouts that require a formed hose path. The hose follows an OEM-style shape to help maintain proper routing between the valve and engine on select 2001-2005 Acura EL and 2001-2005 Honda Civic applications. This part cross-references Dayco 87798 and Continental 64275 for the same application.

The Gates Molded Heater Hose product line focuses on formed replacement hoses that match the routing needs of modern vehicles with limited clearance. For buyers searching for a 2001-2005 Honda Civic heater hose or a 2001-2005 Acura EL molded coolant hose, part number 19329 provides a direct-fit style solution for the specified valve-to-engine position.

Common Problems This Hose Can Address

• Cracked or deteriorated heater hose material
• Improper hose routing in tight engine compartments
• Coolant leaks at a worn molded hose section
• Restricted flow caused by a collapsed or aged hose
• Replacement needs for valve-to-engine heater hose routing

Installation Notes and Tips

Verify the vehicle’s engine configuration and confirm the valve-to-engine routing before installation. This hose is listed for 2001-2005 Acura EL and 2001-2005 Honda Civic models without CVT. Check hose orientation and length against the original part before final fitment, and inspect adjoining clamps, fittings, and coolant passages for wear or contamination.

Quality Assurance

Gates manufactures this molded hose as an OE-style replacement for applications that require accurate shape, size, and routing. The EPDM material and molded construction are selected for service in coolant, water, air, and marine environments.