Gates 19356 HVAC Heater Hose - Heater Inlet

Gates 19356 Molded Heater Hose Overview

The Gates 19356 molded heater hose is an OEM-style coolant hose built for tight engine bays where a straight hose will not route correctly. It is formed to match factory-style bends and is suitable for coolant, water, and air service, with marine application approval.

For Toyota Camry and Toyota Solara heater inlet service, this molded heater hose helps restore proper coolant routing with a fit that follows the original path. The Gates Molded Heater Hose line focuses on factory-shaped replacement hoses for compact engine compartments.

Key Features

• Part number: Gates 19356
• EPDM construction for coolant hose service
• Factory-molded shape for tighter engine compartments
• End I.D.: 0.63 in. (16 mm) on both ends
• Centerline length: 20 in. (508 mm)
• Suitable for coolant, water, and air applications
• Approved for marine applications

Detailed Product Description

This Gates molded coolant hose is built as a direct-style replacement for heater inlet routing where a formed hose is required. The EPDM material and molded profile support consistent routing in confined spaces, helping maintain the original hose path in 2002-2006 Toyota Camry and 2002-2008 Toyota Solara applications. If you are replacing a worn or leaking heater hose, Gates 19356 provides the correct molded configuration for these vehicles.

This part cross-references Dayco 87818 for the same application.

Common Problems This Hose Can Address

• Coolant leaks from a cracked or aged heater hose
• Improper hose routing after a previous repair
• Softening, swelling, or deterioration of the original EPDM hose
• Restricted heater coolant flow caused by a damaged hose
• Fitment issues in compact engine compartments that require a molded hose

Installation Notes and Tips

• Verify heater inlet routing before installation to confirm the molded shape matches the original hose path.
• Inspect adjoining coolant pipes, clamps, and fittings for wear before installing the replacement hose.
• Drain coolant as needed and refill the system according to the vehicle service procedure after installation.
• Confirm the 0.63 in. (16 mm) end diameters and 20 in. (508 mm) centerline length match the application.

Quality Assurance

Gates manufactures this molded heater hose as an OEM-style replacement built for factory-like fit and routing. Part number 19356 is engineered to meet the dimensional requirements of the listed Toyota Camry and Toyota Solara heater inlet applications.

Compatible Vehicles

• Fits 2002-2006 Toyota Camry, Heater Inlet
• Fits 2002-2008 Toyota Solara, Heater Inlet