Gates 19357 HVAC Heater Hose - Heater Outlet

Gates Molded Heater Hose for Toyota Applications

The Gates 19357 molded heater hose is an OEM-style coolant hose built for tight engine bays and factory routing. It is formed to match the original path on select Toyota Camry and Toyota Solara models, helping maintain proper heater circuit flow in the heater outlet location.

Made from EPDM and molded to a specific shape, this Gates Molded Heater Hose is suited for coolant, water, and air applications. It is also approved for marine use, making the Gates 19357 a practical replacement when you need a formed hose that follows the original layout.

Key Features

• OEM-style molded heater hose for factory routing
• EPDM construction for coolant, water, and air service
• End I.D.: 0.63 in. / 16 mm on both ends
• Centerline length: 23.4 in. / 594 mm
• Formed for smaller, tighter engine compartments
• Heater outlet application for select Toyota Camry and Toyota Solara models

Detailed Product Overview

Gates Molded Heater Hose part number 19357 is built as a formed replacement hose for vehicles that require a precise bend and consistent fit. Its molded shape supports original-style routing in the heater outlet area, which is important in compact engine compartments where straight hose sections can create stress or routing issues. This part number 19357 is listed for 2002-2006 Toyota Camry and 2002-2008 Toyota Solara heater outlet applications.

This hose cross-references Dayco 87819 for the same application.

Common Problems This Hose Can Address

• Cracked or hardened heater hose material
• Coolant seepage at a worn hose section
• Poor hose routing in a tight engine bay
• Replacement needs for a formed heater outlet hose
• Loss of proper heater circuit flow due to hose deterioration

Installation Notes and Tips

Verify the hose shape, end inside diameter, and centerline length before installation. This molded hose is intended for heater outlet routing on the listed Toyota Camry and Toyota Solara applications, so compare the original hose path to the replacement part before fitting. Inspect adjoining clamps, fittings, and nearby coolant components for wear or corrosion during service.

Quality Assurance

Gates manufactures this molded heater hose as an OE-style replacement part with factory-formed dimensions for the specified application. The EPDM construction and molded design support consistent fitment in the intended heater outlet location.