Gates 24160 Radiator Coolant Hose - Heater (Upper), Heater Inlet or Heater To Thermostat

Gates Molded Coolant Hose 24160 Overview

The Gates 24160 molded coolant hose is a direct-fit radiator coolant hose built for specific vehicle applications. It uses EPDM, plastic, and steel construction and includes an integrated female quick connector for OE-style routing and connection points.

Compatible with Chevrolet Impala, Chevrolet Malibu, Chevrolet Malibu Limited, and Buick Regal applications listed below, this Gates Molded Coolant Hose 24160 is shaped to match the original hose path and connection layout.

Key Features

• Gates Molded Coolant Hose line for application-specific cooling system replacement
• Part number 24160
• EPDM, plastic, and steel construction
• Molded design with one female quick connector
• 20 mm (0.78 in) inside diameter at both ends
• 23.75 in (603 mm) centerline length
• OE-style modular hose design for factory-style fitment

Product Details

Gates is a recognized aftermarket source for modular coolant hose assemblies, and the Molded Coolant Hose line is built around vehicle-specific configurations. This hose follows the original routing and incorporates an integrated quick-connect fitting, which helps maintain the factory connection style used on the cooling circuit. The Gates 24160 is listed for heater inlet, heater upper, and heater-to-thermostat positions depending on application.

This part cross-references Febi-Bilstein 24160 for the same application.

What This Hose Helps Address

• Cracked or leaking heater hose connections
• Coolant loss at a molded hose section
• Damaged quick-connect interface at the heater circuit
• Improper hose routing after a failed OE hose
• Cooling system service on vehicles with molded modular hose assemblies

Fitment

• Fits 2019 Chevrolet Impala, Heater Inlet
• Fits 2015 Chevrolet Impala, Heater Inlet
• Fits 2014-2017 Buick Regal, Heater (Upper)
• Fits 2016 Chevrolet Malibu Limited, Heater Inlet
• Fits 2013-2015 Chevrolet Malibu, Heater (Upper)
• Fits 2014-2015 Chevrolet Malibu, Heater To Thermostat
• Fits 2014 Chevrolet Impala, Heater (Upper)

Installation Notes

Verify the hose routing, end diameters, and quick-connector style against the removed part before installation. Inspect mating plastic fittings, clamps, and nearby coolant components for wear or heat damage, and refill and bleed the cooling system according to the vehicle service procedure after replacement.

Quality Assurance

Gates manufactures this molded coolant hose to application-specific dimensions and OE-style connection requirements for the listed vehicles. The modular design and integrated connector support factory-style replacement on the cooling system.