Gates 33917 Engine Coolant Thermostat

OE Type Thermostat for Chrysler and Dodge

Gates 33917 is an OE Type Engine Coolant Thermostat built for precise temperature control and a leak-free, OEM-equivalent fit. It is a direct replacement for select Chrysler and Dodge applications, including Chrysler 300, Sebring, Concorde, and Intrepid, as well as Dodge Avenger, Charger, Magnum, Stratus, and Intrepid.

The Gates OE Type Thermostat line focuses on factory-style fit and temperature regulation for everyday cooling system service. This part number 33917 uses a reverse poppet design with steel and copper construction, an O-ring seal, and a jiggle pin weep hole for proper coolant flow and air bleeding during service.

• OE Type thermostat for factory-style cooling system replacement
• Reverse poppet design for controlled coolant flow
• Steel and copper construction
• O-ring seal for leak-resistant installation
• Jiggle pin weep hole for air purge during filling
• Start-to-open temperature: 190°F / 88°C
• OE Performance comparison rating

Detailed Product Overview

Gates 33917 is engineered for drivers and technicians who need a thermostat that matches OE temperature control behavior. It is listed for 2005-2010 Chrysler 300, 2001-2010 Chrysler Sebring, 2008-2010 Dodge Avenger, 2006-2010 Dodge Charger, 2005-2008 Dodge Magnum, 2001-2006 Dodge Stratus, 1998-2004 Chrysler Concorde, 1998-2004 Chrysler Intrepid, and 1998-2004 Dodge Intrepid. If you are searching for a 190 degree thermostat for Chrysler 300 or a replacement thermostat for Dodge Charger cooling system service, this part number 33917 matches those OE-style applications.

This part cross-references Stant 14349 and Motorad 449-190 for the same application.

Common Cooling System Issues It May Address

• Engine running too cool or too hot due to thermostat wear
• Slow warm-up or unstable operating temperature
• Coolant flow problems caused by a sticking thermostat
• Leak concerns at the thermostat seal area
• Air trapped in the cooling system after service

Installation Notes and Tips

Verify the thermostat orientation before installation, especially on reverse poppet applications. Inspect the housing, sealing surfaces, and coolant condition before reassembly. Use the correct O-ring seal and follow the vehicle service procedure for coolant fill and air bleeding so the jiggle pin weep hole can do its job.

Quality Assurance

Gates OE Type Thermostats are built to deliver OEM-equivalent fit and precise temperature control for cooling system maintenance. The OE Performance rating reflects a factory-style replacement standard for dependable service.