Gates 365662 Power Steering Pressure Line Hose Assembly

Gates Pressure Line Assembly for Steering Service

The Gates 365662 pressure line assembly is a power steering pressure hose built for OE performance and direct replacement service. It uses male O-ring ends with 16 mm and 18 mm diameters and a 90-inch length to match the specified steering routing on supported vehicles.

Compatible with Chevrolet Impala and Chevrolet Monte Carlo applications, this Gates Pressure Line Assembly supports pressure-side steering fluid transfer in the power steering system. The Gates pressure line assembly line focuses on application-specific hose routing and OE-style fitment for service work that requires the correct end style and dimensions.

Key Features

• Power steering pressure line hose assembly for steering system repair
• OE Performance rating for OE-style replacement fit
• Male O-ring ends on both connections
• 16 mm end 1 diameter and 18 mm end 2 diameter
• 90-inch overall length
• No switch port included
• Gates part number 365662

Product Details

This Gates 365662 pressure line assembly is built for pressure-side steering fluid delivery between the power steering pump and steering gear on the listed Chevrolet applications. It is a direct-fit style hose assembly for 2006-2011 Chevrolet Impala and 2006-2007 Chevrolet Monte Carlo models, with the correct male O-ring end configuration and diameter sizing for those vehicles. This part cross-references Four Seasons 75022 and Sunsong 3402247 for the same application.

Common Repair Uses

• Restores steering fluid flow after a leaking or damaged pressure hose
• Replaces a cracked, swollen, or corroded power steering line
• Addresses steering assist loss caused by pressure-side hose failure
• Corrects fluid seepage at O-ring connection points
• Supports repair of noisy or inconsistent power steering operation

Installation Notes and Tips

Verify the hose routing, end diameters, and connection style before installation. Confirm the vehicle application by year, make, and model: Fits 2006-2011 Chevrolet Impala, N/A; Fits 2006-2007 Chevrolet Monte Carlo, N/A. Inspect mating surfaces and replace worn O-rings or seals as required by the service procedure. After installation, refill the system with the correct power steering fluid and bleed air from the steering system according to factory service steps.

Quality Assurance

Gates pressure line assemblies are built to OE performance expectations for service replacement use. Part number 365662 is engineered for the specified fitment and connection dimensions to support accurate steering system repair.