Gates 41219 Engine Water Pump - Main

Gates Water Pump for BMW and Mini

The Gates 41219 standard engine water pump is built for BMW X1, BMW X2, and Mini Cooper applications that use an accessory belt drive. It features a cast aluminum housing, plastic impeller, and reverse impeller rotation for the specified cooling system layout. The Gates Water Pump (Standard) line focuses on OE-quality fit and consistent operation for everyday cooling system service.

Key Features

• Part number 41219 for direct replacement planning
• Accessory belt driven water pump design
• Cast aluminum housing for the pump body
• Plastic impeller with reverse rotation
• Pulley included
• Contents: water pump, rubber gasket, and 4 bolts
• Thermostat and housing not included
• Timing belt driven: no

Product Details

Gates 41219 is a standard engine water pump engineered for cooling system service on select BMW X1, BMW X2, and Mini Cooper platforms. It is built with premium alloy materials and is tested for seal and bearing function as well as leakage integrity before release. This part cross-references Eastern Catalytic 41219 and Nissens 941219 for the same application.

Vehicle Fitment

• Fits 2023 BMW X2, Main; W/O Thermostat And Housing; Water Pump (Standard)
• Fits 2018-2021 BMW X2, Main; W/O Thermostat And Housing; Water Pump (Standard)
• Fits 2014-2022 Mini Cooper, Main; W/O Thermostat And Housing; Water Pump (Standard)
• Fits 2016-2022 Mini Cooper Clubman, Main; W/O Thermostat And Housing; Water Pump (Standard)
• Fits 2017-2022 Mini Cooper Countryman, Main; W/O Thermostat And Housing; Water Pump (Standard)
• Fits 2016-2019 BMW X1, Main; W/O Thermostat And Housing; Water Pump (Standard)

Common Replacement Reasons

• Coolant leakage from the pump housing or seals
• Overheating caused by reduced coolant circulation
• Noise from worn bearings in the pump assembly
• Impeller wear affecting coolant flow
• Service replacement when the original pump is no longer reliable

Installation Notes

Verify engine configuration and cooling system layout before ordering, since this pump is specified without thermostat and housing. Confirm accessory belt routing, pulley alignment, and reverse-rotation requirements during installation. Replace the rubber gasket and follow the vehicle manufacturer’s cooling system bleeding procedure after installation.

Quality Assurance

Gates water pumps are manufactured for consistent operation and OE-quality fit. Each new pump is function-tested for seals and bearings and leak-tested at the casting and assembled levels to help confirm proper sealing before installation.