Gates 44006 Engine Water Pump

Gates 44006 Engine Water Pump Overview

The Gates 44006 engine water pump is a standard replacement water pump built for dependable coolant circulation and OE-quality fit. It uses cast iron for both the housing and impeller, with a standard impeller rotation and accessory belt drive for straightforward service on the correct application.

Gates Water Pump (Standard) components are built with premium materials and tested for seal, bearing, and leakage performance before release. For buyers searching for a Gates water pump 44006, this part delivers a direct-fit cooling system replacement for vehicles that use an accessory belt-driven pump.

Key Features

• Cast iron housing for durable cooling system service
• Cast iron impeller with standard rotation
• Accessory belt driven design
• Includes water pump, gasket, and 2 plugs
• 2 outlet configuration
• No back housing, thermostat housing, fan clutch, or pulley included
• Not timing belt driven

Product Details

This Gates engine water pump is built for applications that require a standard-rotation, accessory belt-driven cooling pump. The cast iron construction supports long-term use in demanding engine environments, while the included gasket and plugs help complete the replacement on the correct vehicle. If you are replacing a worn cooling pump on a Ford truck or similar application, the Gates 44006 is a practical OE-style service part.

This part cross-references Standard Ignition WP-518 for the same application.

Common Problems This Part Can Address

• Coolant leakage from a worn pump seal or casting
• Overheating caused by reduced coolant circulation
• Noise from failing pump bearings
• Visible corrosion or wear on the pump housing or impeller
• Cooling system service needs on an accessory belt-driven setup

Installation Notes and Tips

Confirm the vehicle uses a standard-rotation, accessory belt-driven water pump before ordering. Verify outlet count and mounting style against the original part, and inspect the belt, hoses, and cooling passages during replacement. For Ford truck applications and other listed fitments, clean the gasket surface thoroughly before installation and refill the cooling system with the correct coolant mixture.

Quality Assurance

Gates tests each new water pump for seal and bearing function, then performs leakage testing on both the casting and assembled unit. The result is a replacement water pump built to OE-quality fit standards for reliable cooling system service.