Gates 44108 Engine Water Pump

Gates Water Pump for Ford F-150

The Gates 44108 engine water pump is built for 2018-2020 Ford F-150 applications that use a reverse-rotation accessory belt drive. It includes the pulley, back housing, thermostat, thermostat housing, and rubber gasket for a direct replacement focused on cooling-system service.

Gates Water Pump (Standard) components are built with premium alloy materials and tested for seal, bearing, and leakage performance before release. For Ford F-150 cooling system repair, this part number 44108 provides an OE-quality fit with the features needed for a complete water pump replacement.

Key Features

• Fits 2018-2020 Ford F-150, N/A
• Part number 44108 for cooling system service
• Cast aluminum housing for strength and heat resistance
• Plastic impeller with reverse rotation design
• Accessory belt driven, not timing belt driven
• Pulley included with back housing included
• Thermostat and housing included
• Two outlets for the listed application

Detailed Description

This Gates engine water pump is engineered for Ford F-150 models from 2018 through 2020 and is listed as a standard-position replacement. The reverse impeller rotation and accessory belt drive match the specified cooling-system configuration, while the cast aluminum housing and plastic impeller support reliable coolant circulation under normal operating conditions. The Gates 44108 water pump is a practical choice when replacing a worn pump, thermostat assembly, or leaking housing on the Ford F-150.

Gates Water Pump (Standard) is a product line focused on replacement cooling components built to meet OE-style fit and function. This part cross-references Four Seasons 44108 and GMB 125-6110 for the same application.

Common Repair Symptoms

• Coolant leakage from the water pump or housing
• Overheating caused by reduced coolant circulation
• Noise from worn pump bearings or seals
• Thermostat-related temperature control issues
• Cooling-system service on a Ford F-150 with the listed belt-drive setup

Installation Notes and Tips

Verify reverse-rotation belt routing before installation, since this pump is not timing-belt driven. Inspect the mating surfaces, replace damaged hoses or clamps as needed, and confirm the thermostat housing seals correctly after assembly. Always bleed the cooling system according to the vehicle service procedure after installation on a 2018-2020 Ford F-150.

Quality Assurance

Gates states that each new water pump is built from premium alloy materials and undergoes functional testing of seals and bearings, plus leakage testing of the casting and assembled unit. That testing supports consistent fit and dependable cooling-system performance for the Ford F-150 application.