GBR 825-11118 Fuel Injector

Reman GDI Fuel Injector for Ford Applications

The GBR 825-11118 is a remanufactured GDI fuel injector built for direct-fit replacement in select Ford fuel injection systems. It is engineered for consistent fuel delivery, accurate spray pattern control, and OE-style fitment for service work on the Ford Mustang and Ford F-150.

The GBR reman fuel injector line uses a 15-step remanufacturing process in a U.S.-based facility. Each injector is tested across multiple operating conditions to verify flow rate, spray pattern, coil resistance, form, fit, and function against OE specifications.

Key Features

• Remanufactured OEM-style GDI fuel injector
• Built for direct replacement in select Ford Mustang and Ford F-150 applications
• Tested for flow rate, spray pattern, coil resistance, form, fit, and function
• Remanufactured through a 15-step process in the USA
• Part number 825-11118 for catalog and service identification

Product Details

GBR’s Reman GDI Fuel Injector line focuses on restoring OE-level performance for gasoline direct injection systems. This injector is cross-referenced to JR3Z9F593A for the same application and is intended for vehicles that require precise fuel metering under direct-injection operating conditions. Fits 2018-2023 Ford Mustang, N/A. Fits 2018-2020 Ford F-150, N/A. The 825-11118 injector is a practical service replacement when the original injector shows signs of wear, imbalance, or inconsistent delivery.

Common Issues This Part May Address

• Rough idle caused by uneven fuel delivery
• Hard starting related to injector performance loss
• Misfire conditions tied to poor spray pattern or flow variation
• Fuel trim imbalance from a worn or contaminated injector
• Driveability concerns in direct-injection fuel systems

Installation Notes and Tips

Verify engine and VIN-specific fitment before installation. For 2018-2023 Ford Mustang and 2018-2020 Ford F-150 applications, follow factory service procedures for injector replacement and sealing. Replace the fuel filter when the injector is replaced where applicable, and inspect the fuel system for contamination before installing the new injector. Confirm electrical connector condition and fuel rail sealing surfaces during service.

Quality Assurance

Each GBR remanufactured injector is tested to meet or exceed OE specifications for key operating characteristics, including flow, spray pattern, and coil resistance. The 825-11118 is produced through a controlled remanufacturing process designed to support consistent performance in Ford Mustang and Ford F-150 fuel injection service.