GBR 845-12106 Fuel Injector

Reman GDI Fuel Injector for Hyundai and Kia

GBR 845-12106 is a remanufactured GDI fuel injector built for direct-fit replacement in select Hyundai and Kia applications. It is remanufactured in the USA and tested across multiple operating conditions to verify flow rate, spray pattern, coil resistance, form, fit, and function.

This reman GDI fuel injector is a practical replacement for vehicles that need restored fuel delivery performance, including Hyundai Sonata, Hyundai Santa Fe Sport, Kia Optima, and Kia Sportage applications.

Key Features

• Remanufactured OEM fuel injector from GBR
• Proven 15-step remanufacturing process
• 100% tested under multiple operating conditions
• Verified against OE specifications for flow rate and spray pattern
• Checked for coil resistance, form, fit, and function
• Includes new external seals and o-rings
• Part number 845-12106 for easy identification

Product Details

GBR’s Reman GDI Fuel Injector line focuses on restoring original equipment performance through controlled remanufacturing and testing. Part number 845-12106 is built for direct replacement use on 2011-2014 Hyundai Sonata, 2013-2016 Hyundai Santa Fe Sport, 2011-2015 Kia Optima, and 2011-2015 Kia Sportage applications. This part cross-references 353102G720 for the same application.

Common Replacement Uses

• Restores proper fuel atomization after injector wear or clogging
• Addresses rough idle caused by inconsistent injector spray pattern
• Helps correct fuel delivery issues that can trigger drivability complaints
• Supports repair of hard-start or extended-crank conditions tied to injector performance
• Replaces a failed injector in Hyundai Sonata, Kia Optima, and related GDI applications

Installation Notes

Verify vehicle application by year, make, and model before installation. Follow the service procedure for the specific Hyundai or Kia engine configuration, and inspect the fuel system for contamination or related faults that could affect injector performance. New external seals and o-rings are included, but proper sealing surfaces and torque procedures still matter during installation.

Quality Assurance

Each injector is remanufactured in a U.S.A. facility using a 15-step process and tested to meet or exceed OE specifications for critical operating characteristics. The part is evaluated for flow, spray pattern, coil resistance, form, fit, and function before release.