Home› Driveline and Axles > Service Kits› GKN Loebro 300593 CV Joint Boot Kit - Front Outer
GKN Loebro 300593 CV Joint Boot Kit - Front OuterOE Quality 60-Day Returns
Part #: 300593

GKN Loebro 300593 CV Joint Boot Kit - Front Outer

Front Outer
6 vehicles fit this part
Select your vehicle to confirm fitment
Verify this part fits before purchasing — free returns if it doesn't
$28.69Free Shipping
Free ShippingNo Cost to Continental U.S.
Free Returns*Wrong fit? No cost
60-Day ReturnsMoney back guarantee
*Free return shipping only qualifies if our fitment verification tool is used.
In Stock · Ready To Ship Most orders ship same-day if ordered before 1pm CST.
OE Direct Replacement — Bolt-on fit, no modifications needed
Fitment: Saab, 9000
Easy Returns — Return within 60 days for a full refund
Fast Shipping — Most orders ship same business day before 1pm CST
Not what you need? See all CV Joint Boot Kit options

OE-Quality CV Boot Kit for Saab 9000

GKN Loebro 300593 is a premium OE-quality CV joint boot kit built for the front outer position on 1995-1998 Saab 9000 models. It is made with a solid rubber boot and the correct joint-side and shaft-side dimensions for a precise replacement on the specified application.

  • Fits 1995-1998 Saab 9000, front outer
  • Solid rubber boot in black finish
  • Joint end inside diameter: 2.913 in.
  • Shaft end inside diameter: 0.984 in.
  • Single-rib boot design
  • Non-vented construction
  • Part number: 300593

Built Around Exact Fitment

This GKN Loebro CV joint boot kit is engineered around the dimensions of the original joint, which matters because torn, slipped, or porous boots are common causes of CV joint failure. For Saab 9000 front outer service, the correct boot material and fit are critical to keeping grease contained and contaminants out. If the original driveshaft uses a TPE boot, GKN Automotive recommends matching that material type rather than substituting a different boot construction. Part number 300593 is intended for direct replacement on the listed Saab 9000 applications.

This part cross-references 89 93 701 for the same application.

Common Problems This Part Addresses

  • Split or torn CV boot on the front outer joint
  • Grease leakage around the axle joint
  • Road debris and moisture entering the CV joint
  • Boot slippage caused by incorrect fitment
  • Wear that can lead to joint noise or accelerated CV joint damage

Installation Notes and Tips

Inspect the CV joint before installation and replace the boot only if the joint remains serviceable. Clean the joint thoroughly, pack it with the correct grease for the application, and confirm the boot seats fully on both the shaft and joint ends before tightening. Verify the boot orientation and dimensions against the original part before final assembly on the Saab 9000 front outer axle.

Quality Assurance

GKN Loebro is part of GKN Automotive, a global driveline specialist known for OE-quality drive system components. The 300593 boot kit is supplied as a professional repair solution with the parts needed for a proper boot replacement on the specified vehicle application.

BrandGKN Loebro
Part Number300593
Boot Colorblack
Boot MaterialRubber
Joint End Inside Diameter2.913
Rib Quantity1
Shaft End Inside Diameter0.984
Split Or Solid TypeSolid
Vented BootNo

This part fits 6 vehicles. Search below:

YearMakeModelDrive TypeTransmissionLitersCylindersPositionNotes
1998Saab9000FWD2.3LL4Front Outer
1997Saab9000FWD2.3LL4Front Outer
1997Saab9000FWDAutomatic2.3LL4Front Outer
1996Saab9000FWD2.3LL4Front Outer
1996Saab9000FWDAutomatic2.3LL4Front Outer
1995Saab9000FWD2.3LL4Front Outer

* Always verify fitment with your vehicle's VIN if unsure. Submodel & trim restrictions may apply.

This part directly replaces or is cross-referenced with the following part numbers:

89 93 701

Cross-reference numbers are provided for identification purposes only. Always confirm fitment before ordering.

Related Articles