GKN Loebro 305146 CV Joint Boot Kit

OE-Style CV Boot Kit for Volvo Front Inner Axles

GKN Loebro 305146 is a premium OE-quality CV joint boot kit for front inner applications on select Volvo models. It is built for the exact fit and material match needed to protect the joint from contamination, grease loss, and premature wear.

For Volvo V70, C70, and S70 front inner service, this GKN Loebro 305146 boot kit is designed around the joint dimensions and TPE construction used on the original driveline setup.

Key Features

• OE-quality CV joint boot kit from GKN Loebro
• Solid black TPE boot for standard replacement service
• Length: 98 mm
• Joint end inside diameter: 3.582 in
• Shaft end inside diameter: 1.142 in
• Single-rib design with vented boot: No
• Includes grease
• Fits front inner driveline positions on select Volvo applications

Detailed Description

GKN Loebro 305146 is a CV joint boot kit engineered for exact-fit replacement on front inner driveline assemblies. The boot material is TPE, which matters when the original driveshaft uses a TPE boot, since matching the original material helps maintain proper flexibility and sealing performance. This kit is intended for 1999-2007 Volvo V70 front inner, 1999-2004 Volvo C70 front inner, and 1999-2000 Volvo S70 front inner applications. If you are servicing a Volvo V70 CV boot, Volvo C70 front inner axle boot, or Volvo S70 CV joint boot replacement, part number 305146 provides the dimensions and material match needed for the repair.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What It Helps Address

• Torn CV boot material that exposes the joint to dirt and moisture
• Slipped boot sealing that allows grease to escape
• Porous boot material that can lead to contamination
• Noise or vibration caused by a worn, under-protected CV joint
• Front inner axle service needs on select Volvo driveline assemblies

Installation Notes and Tips

Confirm the joint end and shaft end diameters before installation, and verify that the original application uses TPE material. Exact fit is important on CV boot replacement because the boot must seal correctly to the joint and shaft. Clean the joint thoroughly before assembly, inspect for wear or damage, and follow the vehicle service procedure for clamp and grease application. This kit is intended for front inner positions only on the listed Volvo applications.

Quality Assurance

GKN Loebro supplies OE-quality driveline components backed by its experience as a global drive systems manufacturer. Part number 305146 is built as a standard replacement boot kit for precise fitment and reliable sealing performance on the specified Volvo applications.