GKN Loebro 305627 CV Joint Boot Kit - Front Outer

OE-Quality CV Boot Kit for Range Rover

GKN Loebro 305627 is an OE-quality TPE CV joint boot kit for the front outer position on select Land Rover Range Rover applications. It is built to match the joint’s dimensions and material requirements, helping protect the CV joint from contamination and heat-related wear.

For Range Rover front outer CV boot replacement, exact fit matters. This GKN Loebro 305627 boot kit is designed for vehicles with the correct OE-style TPE boot specification, including 2002-2009 Land Rover Range Rover and 2010-2012 Land Rover Range Rover with VIN starting from AA000001.

Key Features

• OE-quality CV joint boot kit from GKN Automotive
• Thermoplastic elastomer (TPE) boot material for heat resistance
• Solid black boot design
• Designed for the front outer CV joint position
• Joint end inside diameter: 4.062 in.
• Shaft end inside diameter: 1.334 in.
• Rib quantity: 1
• Non-vented boot construction

Detailed Description

GKN Loebro 305627 is a replacement CV joint boot kit engineered for driveline service on Land Rover Range Rover front outer applications. The TPE construction is important on modern drivetrains because higher torque and operating temperatures can accelerate boot failure when the material does not match the original design. If the original driveshaft uses a TPE boot, this replacement should match that specification for proper fit and protection. This part cross-references Land Rover OE numbers LR032576 and TDR000110 for the same application.

What It Helps Address

• Torn CV boots that expose the joint to dirt and moisture
• Slipped boots that no longer seal correctly
• Porous or aged boots that allow grease loss
• CV joint contamination that can lead to noise and wear
• Front outer driveline service on Range Rover models

Installation Notes and Tips

• Verify the original boot material before ordering; this application calls for TPE.
• Confirm the front outer position and the VIN break for 2010-2012 Range Rover models.
• Measure the joint and shaft ends to confirm the listed inside diameters.
• Inspect the CV joint for damage before installing a new boot.
• Use the correct clamp and seal procedure so the boot seats evenly and retains grease.

Quality Assurance

GKN Automotive is a global driveline manufacturer with OE-level engineering focus, and this GKN Loebro 305627 boot kit is built to the same fit and material expectations used for original-equipment service on the listed Range Rover applications.