Global Parts 1813238 Mass Air Flow Sensor Assembly

Mass Air Flow Sensor Assembly for Ford Applications

Global Parts 1813238 is a mass air flow sensor assembly for select Ford and Mercury vehicles with sensor and housing configuration. It measures incoming air volume and density so the engine control unit can calculate fuel delivery and ignition timing with greater precision. This part number 1813238 is a direct-fit option for common Ford truck, van, and car applications.

Key Features

• Mass air flow sensor assembly with housing
• Measures intake air volume and density for engine management
• Supports accurate fuel-to-air ratio control
• Fits select Ford Ranger, Mustang, Explorer, and related models
• Global Parts part number 1813238

Detailed Description

Compatible With 1995-2000 Ford Ranger, 1996-1999 Ford Mustang, 1996-1998 Ford Explorer, 1997-1998 Mercury Mountaineer, and select 1995-1996 Ford and Mercury vehicles listed below, this mass air flow sensor assembly is built for intake-system service where airflow measurement is critical. It helps the engine control unit interpret incoming air so the engine can maintain proper combustion, throttle response, and fuel control. This part cross-references MA1017 for the same application.

Global Parts 1813238 is also listed for 1996 Ford E-150 Econoline, E-150 Econoline Club Wagon, E-250 Econoline, E-350 Econoline, E-350 Econoline Club Wagon, F-150, and F-350, plus 1995 Ford Crown Victoria and 1995 Mercury Grand Marquis. Use this part number 1813238 when replacing a worn or inaccurate airflow sensor assembly on the specified Ford and Mercury platforms.

What It Helps Address

• Rough idle caused by incorrect airflow readings
• Hesitation or poor throttle response
• Fuel mixture issues from inaccurate intake air measurement
• Check engine light related to mass air flow sensor faults
• Reduced engine efficiency from unstable air metering

Installation Notes and Tips

Verify the vehicle year, make, model, and sensor-with-housing configuration before ordering. Inspect the intake tract, air filter, and electrical connector condition during replacement, and clear diagnostic trouble codes after installation if required by the vehicle service procedure. Confirm fitment for your specific Ford Ranger, Mustang, or Explorer application using the listed vehicle coverage.

Quality Assurance

Global Parts supplies this emission control sensor assembly as a replacement component for the listed applications. The design follows the function of the original airflow sensor by providing intake air measurement data to the engine control unit for fuel and ignition control.