Global Parts 1813452 Disc Brake Pad Wear Sensor - Rear

Rear Brake Wear Sensor for Land Rover

Global Parts 1813452 is a direct replacement disc brake pad wear sensor for rear brake applications on 2006-2012 Land Rover Range Rover models. It monitors brake pad thickness and sends a wear alert when the pads thin to a service point, helping maintain consistent brake system monitoring.

Key Features

• Direct replacement brake pad wear sensor for rear position
• Fits 2006-2012 Land Rover Range Rover, rear
• Pin terminal design with 2-wire construction
• Round female connector with male terminals
• Wiring harness included for the sensor connection
• Built for accurate brake wear detection and service alerts
• Part number 1813452 for easy identification

Detailed Description

This Global Parts brake wear sensor is engineered for rear brake pad monitoring on the Land Rover Range Rover. The sensor uses a 2-wire layout with a round female connector, pin terminals, and male terminal ends to match the original-style connection point. As brake pads wear down, the sensor provides a signal that helps indicate when replacement service is due. Part number 1813452 is also referenced by Holstein 2BWS0186 and Raybestos Brakes WK616 for the same application.

For buyers searching for a rear brake pad wear sensor for 2006-2012 Land Rover Range Rover, this direct replacement part supports accurate wear detection without changing the vehicle’s brake monitoring setup. The Global Parts 1813452 sensor is a practical choice when replacing a damaged or worn brake wear sensor on the rear axle.

What It Helps Address

• Brake wear warning light or sensor fault related to rear pads
• Damaged, brittle, or broken brake pad wear sensor wiring
• Inaccurate brake pad wear detection on the rear axle
• Service alerts caused by a failed sensor connection
• Need for a direct replacement brake wear sensor for Land Rover Range Rover

Installation Notes and Tips

Verify rear-position fitment before ordering and compare the connector shape, terminal count, and wire layout to the original sensor. Inspect the brake pad wear sensor routing during installation to confirm the harness is seated correctly and protected from heat, movement, and abrasion. Confirm the vehicle application as Fits 2006-2012 Land Rover Range Rover, rear.

Quality Assurance

Global Parts supplies this brake wear sensor as a direct replacement component for the listed Land Rover Range Rover applications. The design follows the original connection style and wear-sensing function expected for rear brake service on these vehicles.