GMB 215-1306 Universal Joint

GMB 215-1306 Universal Joint

GMB 215-1306 is an OEM-standard universal joint built for driveline service where greaseable construction and precise cap sizing matter. Manufactured to meet or exceed OEM specifications, it is a direct-fit option for a wide range of Dodge, Chrysler, Plymouth, and Jeep driveline applications.

Fits 1997-1999 Dodge Dakota, rear shaft all joints, and other confirmed applications across Dodge Ramcharger, W150, W250, W350, and Chrysler intermediate shaft setups.

Key Features

• OEM Standard universal joint for driveline and axle service
• 1.0800 in bearing cap diameter on both axes
• Inside snap ring style (ISR) for retained fitment
• Greasable design with grease zerks included
• Pre-greased for initial service readiness
• Chrome-molybdenum steel cross for strength and wear resistance
• Machined bearing cap finish with nitrile rubber seals

Detailed Description

This GMB universal joint is built for vehicles that use an inside snap ring style joint with 1.0800-inch bearing caps. The greasable design supports routine maintenance, while the pre-greased construction helps simplify installation prep. It is a practical replacement for rear shaft, front shaft, and intermediate shaft applications found in classic and late-model Dodge, Chrysler, Plymouth, and Jeep driveline systems. This part cross-references MOOG Driveline Products 245 for the same application. Part number 215-1306 is also listed under multiple aftermarket interchange numbers for broad catalog matching.

Common Driveline Issues It Can Address

• Driveline vibration from worn universal joint bearings
• Clunking or clicking during acceleration and deceleration
• Loose or rough driveline movement at the shaft connection
• Grease loss or dry-joint wear in serviceable U-joint applications
• Replacement needs on rear shaft all joints, front shaft front joint, or intermediate shaft positions

Installation Notes and Fitment Tips

• Verify bearing cap diameter, snap ring style, and shaft configuration before installation.
• Confirm the vehicle uses an inside snap ring style joint with 1.0800-inch caps.
• Fits 1997-1999 Dodge Dakota, rear shaft all joints.
• Fits 1994-1996 Dodge Ram 3500, rear shaft all joints.
• Fits 1977-1993 Dodge Ramcharger, front shaft front joint.
• Fits 1974-1980 Jeep Cherokee, rear shaft rear joint.
• Fits 1984-1993 Chrysler Voyager, front axle shaft at support bearing, w/ U-joint style intermediate shaft.
• Use the grease fitting to service the joint at regular intervals after installation.

Quality Assurance

GMB states this part is manufactured to meet or exceed OEM specifications. The OEM Standard grade, chrome-molybdenum steel cross, machined caps, and nitrile rubber seals reflect a service-focused replacement built for driveline applications that require accurate fit and maintainable operation.