Hella 009110441 Engine Crankshaft Position Sensor - Rear

Hella Crankshaft Position Sensor for Mercedes-Benz

Restore accurate engine timing signal input with this Hella crankshaft position sensor, part number 009110441. It uses an inductive sensor design with a 2-pin round plug and a 1340 mm cable for flywheel-side mounting on select Mercedes-Benz applications.

Hella Electronics brings OE-level sensor experience to this replacement crankshaft position sensor for Mercedes-Benz 300E, 300CE, 300TE, 300SL, S320, and SL320 applications.

Key Features

• Part number: 009110441
• Inductive crankshaft position sensor
• Flywheel-side fitting position
• 2 poles with round plug connection
• 12V rated voltage
• 830 ohm resistance
• 1340 mm cable length
• 10% tolerance

Detailed Product Overview

This Hella engine crankshaft position sensor monitors crankshaft rotation and sends the signal the engine management system uses for ignition and fuel timing. The flywheel-side mounting location and inductive design match the OE-style configuration used on many Mercedes-Benz inline-six and V12-era applications. If you are replacing a failing Mercedes-Benz crankshaft position sensor, 009110441 provides the correct electrical and connector layout for direct service on listed vehicles.

This part cross-references Beck/Arnley 180-0457 and Standard Ignition PC393 for the same application.

What This Sensor Helps Address

• Hard starting or no-start conditions caused by missing crankshaft signal
• Intermittent stalling from unstable engine speed input
• Misfire or timing-related drivability complaints
• Check engine light concerns tied to crankshaft sensor faults
• Rough idle or poor throttle response from incorrect timing data

Installation Notes and Fitment

Fits 1994-1995 Mercedes-Benz S320, N/A. Fits 1994-1995 Mercedes-Benz SL320, N/A. Fits 1990-1993 Mercedes-Benz 300E, Rear. Fits 1990-1993 Mercedes-Benz 300SL, Rear. Fits 1990-1993 Mercedes-Benz 300TE, Rear. Fits 1992 Mercedes-Benz 300CE, N/A. Fits 1990-1991 Mercedes-Benz 300CE, Rear. Fits 1989 Mercedes-Benz 300CE, Rear. Fits 1987-1989 Mercedes-Benz 300E, Rear. Fits 1988-1989 Mercedes-Benz 300TE, Standard. Fits 1988 Mercedes-Benz 300CE, Standard. Fits 1986 Mercedes-Benz 300E, Standard.

Verify the flywheel-side sensor location, 2-pin round plug, and cable routing before installation. Compare the OE reference numbers listed for your vehicle, including 002 153 90 28 and 002 153 92 28 where applicable, to confirm the correct application.

Quality Assurance

Hella is known for OE electronics competence spanning more than 60 years, and this sensor is built to match the electrical and connector requirements used in the listed Mercedes-Benz applications.