Hella 012680001 Engine Crankshaft Position Sensor

Engine Crankshaft Position Sensor Overview

This Hella engine crankshaft position sensor is built for Volvo applications that require a 2-pole inductive sensor with a 315 mm cable. It uses a 12-volt electrical rating and 300 ohm resistance for direct replacement-style service on the listed vehicles.

• Inductive sensor design for crankshaft position signal input
• 2-pole electrical connection
• 315 mm cable length for routing flexibility
• 12 V rated voltage and 300 ohm resistance
• Fits Volvo 850, 960, C70, S70, S90, V70, and V90 applications listed below

Fitment Details

Compatible with these Volvo applications: Fits 1998 Volvo C70, N/A; Fits 1998 Volvo S70, N/A; Fits 1997-1998 Volvo S90, N/A; Fits 1998 Volvo V70, N/A; Fits 1997-1998 Volvo V90, N/A; Fits 1993-1997 Volvo 850, N/A; Fits 1992-1997 Volvo 960, N/A.

For Volvo 850 and Volvo 960 service, this sensor matches the listed electrical and connector specifications shown in the fitment data. The Hella 012680001 is also referenced by multiple aftermarket part numbers for the same application, including Standard Ignition PC272 and Delphi SS11750.

What It Is Used For

• Replacing a failed crankshaft position sensor
• Restoring engine speed and crank signal input
• Addressing intermittent no-start conditions tied to sensor output
• Correcting stalling or rough running caused by signal loss
• Resolving diagnostic trouble codes related to crankshaft position sensing

Installation Notes and Quality

Verify connector style, cable length, and electrical specifications against the original part before installation. This sensor is identified as Hella part number 012680001 and cross-references Standard Ignition PC272 and Delphi SS11750 for the same application.

Hella supplies this sensor as an inductive replacement component with the listed voltage, resistance, and pole count specifications for the covered Volvo fitments.