Holstein 2ABS3005 ABS Wheel Speed Sensor - Front, Front Left or Front Right

Holstein ABS Wheel Speed Sensor for Jeep Cherokee

Holstein Parts 2ABS3005 is an ABS wheel speed sensor for select Jeep Cherokee front applications. It uses a 2-terminal, pin-style connection with an oval female connector and male terminals for a direct-fit electrical interface.

Key Features

• ABS wheel speed sensor for front axle applications
• 2-terminal pin design with oval connector shape
• Female connector and male terminal configuration
• Fits Jeep Cherokee front left and front right applications listed below
• Cross-references Standard Ignition ALS2805 for the same application

Product Details

Holstein Parts 2ABS3005 is built for select Jeep Cherokee models that use a front-mounted ABS wheel speed sensor. This sensor supports the vehicle’s wheel speed monitoring system, helping the ABS control module read wheel rotation data accurately. The Holstein Parts line focuses on application-specific replacement parts, and this sensor matches the connector style and terminal layout called out for the listed Cherokee fitments. If you are replacing a front ABS sensor on a Jeep Cherokee, 2ABS3005 provides a direct match for the confirmed years and positions.

Fits 2023 Jeep Cherokee, front. Fits 2021-2022 Jeep Cherokee, front. Fits 2020 Jeep Cherokee, front. Fits 2019 Jeep Cherokee, front right and front left. Fits 2018 Jeep Cherokee, front left and front right. Fits 2017 Jeep Cherokee, front left and front right. Fits 2014-2016 Jeep Cherokee, front right and front left.

This part cross-references Standard Ignition ALS2805 for the same application.

Common Issues This Sensor May Address

• ABS warning light related to a faulty front wheel speed sensor
• Intermittent wheel speed signal loss at the front axle
• Brake system fault codes tied to sensor circuit problems
• Erratic ABS operation caused by damaged sensor wiring or connector wear
• Loss of accurate wheel speed input on Jeep Cherokee front applications

Installation Notes and Tips

Confirm the vehicle year, trim, suspension configuration, and sensor position before ordering. This listing includes front left and front right applications where noted, including Cherokee models with standard suspension, normal duty suspension, Euro suspension, and specific harness requirements shown in the fitment data. Inspect the connector shape, terminal count, and mounting point on the original sensor before installation. Clear any stored ABS codes after replacement and verify proper wheel speed signal operation.

Quality Assurance

Holstein Parts 2ABS3005 is cataloged for the confirmed Jeep Cherokee applications listed above and follows the specified connector and terminal configuration for those vehicles.