Holstein 2CAM0036 Engine Crankshaft Position Sensor

Holstein Engine Crankshaft Position Sensor

Holstein Parts 2CAM0036 is an engine crankshaft position sensor built for direct-fit replacement on a wide range of Audi and Volkswagen applications. It uses a 3-terminal blade-style connection with a female connector and male terminals for straightforward electrical interface on the listed vehicles.

Compatible with Audi TT, A4, A3, TTS Quattro, and Volkswagen Jetta, Golf, GTI, Passat, and Beetle applications, this sensor supports accurate crankshaft signal input for proper engine management. The Holstein Parts line focuses on application-specific replacement components for import vehicles, and 2CAM0036 follows that approach for common VW and Audi fitments.

• Engine crankshaft position sensor for ignition and engine management systems
• Blade terminal type with 3 terminals
• Female connector gender with male terminals
• Direct-fit replacement for select Audi and Volkswagen models
• Cross-references Beck/Arnley 180-0381 and Delphi SS10811 for the same application

Detailed Fitment and Function

This crankshaft position sensor monitors crankshaft position and rotational timing so the engine control system can calculate ignition and fuel events accurately. Holstein 2CAM0036 is listed for 2000-2015 Audi and Volkswagen vehicles, including Fits 2005-2009 Audi A4, N/A; Fits 2005-2009 Audi A4 Quattro, N/A; Fits 2001-2010 Audi TT, N/A; Fits 2006-2008 Volkswagen GTI, N/A; Fits 2001-2015 Volkswagen Jetta, N/A; and Fits 2000-2007 Volkswagen Golf, N/A. Additional coverage includes Fits 2009-2015 Audi TTS Quattro, N/A and Fits 2012-2013 Volkswagen Golf R, N/A.

Common Issues This Sensor Can Address

• Engine no-start or intermittent start condition related to crank signal loss
• Rough running or stalling caused by inaccurate crankshaft position input
• Check engine light with crankshaft position sensor fault codes
• Misfire or timing-related drivability concerns on listed Audi and Volkswagen models
• Hard starting after heat soak or during extended cranking

Installation Notes and Tips

Verify the connector style, terminal count, and vehicle application before installation. Inspect the harness connector for corrosion, bent terminals, or damaged locking tabs, and confirm the sensor mounting location matches the original part on the vehicle. For best results, clear stored fault codes after installation and confirm proper engine operation during a road test.

Quality Assurance

Holstein Parts supplies application-specific replacement sensors for import vehicle service, and this part is built to match the listed electrical connection and fitment requirements for the covered Audi and Volkswagen applications.