Holstein 2KNC0314 Ignition Knock (Detonation) Sensor

Holstein Knock Sensor for Mazda and Ford

Holstein Parts 2KNC0314 is an ignition knock sensor for select Mazda and Ford applications. It uses a rectangular female connector with two female terminals and a blade-style terminal design for direct electrical connection in the engine management system.

Compatible With 1995-2002 Mazda 626, 1995-1997 Ford Probe, 1995-1997 Mazda MX-6, 1995-1996 Mazda Millenia, and 1995 Mazda MX-3. The Holstein Parts line focuses on replacement electrical and emission control components built for vehicle-specific fitment.

Key Features

• Ignition knock (detonation) sensor for engine knock detection
• Rectangular female connector for OE-style electrical interface
• Blade terminal type with 2 terminals
• 1 connector configuration for simplified identification
• Direct-fit replacement for select Mazda 626 and Ford Probe applications
• Holstein Parts 2KNC0314 cross-references Standard Ignition KS73

Detailed Description

The Holstein 2KNC0314 knock sensor monitors engine vibration patterns and sends a signal to the engine control system when detonation is detected. That signal helps the ECU adjust ignition timing to maintain proper combustion control. This part number is used across select Mazda and Ford models, including Mazda 626, Mazda MX-6, Mazda Millenia, Mazda MX-3, and Ford Probe applications.

For buyers searching for a Mazda 626 knock sensor, Ford Probe knock sensor, or Mazda MX-6 detonation sensor, Holstein Parts 2KNC0314 provides a vehicle-specific replacement option with the connector and terminal layout needed for the listed applications.

What It Helps Address

• Knock sensor fault codes related to detonation detection
• Rough engine operation caused by incorrect ignition timing response
• Reduced drivability from a failed engine knock signal
• Check engine light concerns tied to the knock sensor circuit
• Intermittent sensor signal issues on listed Mazda and Ford models

Installation Notes and Tips

Verify connector shape, terminal count, and vehicle fitment before installation. Inspect the harness connector for corrosion or damaged terminals, and confirm the mounting surface is clean so the sensor can read engine vibration accurately. Because mounting hardware is not included, reuse or source the required hardware separately if your application calls for it.

Quality Assurance

Holstein Parts supplies replacement electrical and emission control components for specific vehicle applications. This part is built to match the listed connector and terminal configuration for the confirmed fitment range.