InMotion WA512148 Wheel Bearing and Hub Assembly - Rear

Rear Wheel Bearing and Hub Assembly for Mirage and Colt

The InMotion WA512148 is a rear wheel bearing and hub assembly built for direct replacement on select Mitsubishi Mirage and Dodge Colt applications. It is engineered from OE data and measurements to match the original fit, mounting points, and operating dimensions for the listed vehicles.

Fits 1993-2002 Mitsubishi Mirage, rear standard grade. Fits 1993-1995 Dodge Colt, rear standard grade.

Key Features

• Rear wheel bearing and hub assembly for driveline and axle service
• Direct replacement design for the original hub assembly
• Manufactured with high-precision processes and strict quality-control criteria
• OE-based dimensions for fitment, performance, and service life
• 4 wheel studs with 100.0 bolt circle diameter
• Wheel pilot diameter: 55.9 mm
• Brake pilot diameter: 64.0 mm
• Hub pilot diameter: 67.3 mm
• Flange diameter: 125.5 mm; flange offset: 56.5 mm
• Anti-lock brake sensor not included

Detailed Description

InMotion WA512148 is a rear hub assembly for Mitsubishi Mirage and Dodge Colt models listed below. It is built as an OE-style replacement using application-specific measurements to support correct wheel mounting, brake interface alignment, and hub positioning. The 4-stud design, 100.0 mm bolt circle diameter, and matched pilot dimensions help maintain the original assembly geometry on the rear axle.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Use WA512148 when replacing a worn rear wheel bearing and hub assembly on a 1993-2002 Mitsubishi Mirage or a 1993-1995 Dodge Colt. The part number WA512148 is also helpful when verifying the correct rear hub assembly before ordering service components for these vehicles.

Common Repair Reasons

• Rear wheel bearing noise or rough rotation
• Excessive hub play or looseness at the wheel
• Uneven brake rotor seating caused by hub wear
• Vibration or wheel wobble from a worn rear hub assembly
• Corrosion or damage at the wheel mounting surface

Installation Notes

Confirm rear-position fitment before installation and verify the wheel stud count, bolt circle diameter, and pilot dimensions against the removed part. Because the anti-lock brake sensor is not included, transfer or reuse the vehicle’s existing sensor arrangement where applicable. Always inspect related brake and suspension components during hub replacement, and torque fasteners to the vehicle manufacturer’s specifications.

Quality Assurance

InMotion manufactures this hub assembly with OE data, precise measurements, and controlled production standards to support proper fit and consistent service performance. Part number WA512148 is produced as a direct replacement for the listed rear applications.