InMotion WA512211 Wheel Bearing and Hub Assembly - Rear

Rear Wheel Bearing Hub Assembly for Sequoia

InMotion WA512211 is a rear wheel bearing and hub assembly built for 2001-2007 Toyota Sequoia Standard Grade applications. It is engineered from OE data and measurements for direct replacement fitment, with precision manufacturing and controlled quality checks to support proper wheel mounting and long service life.

Key Features

• Fits 2001-2007 Toyota Sequoia, rear
• Part number: WA512211
• Wheel bearing and hub assembly for driveline and axle service
• 4 flange bolt holes for secure mounting
• Hub pilot diameter: 106.0 mm
• Bolt circle diameter: 5.51 in
• Flange offset: 59.5 mm
• ABS sensor not included
• Designed as a direct replacement for the original hub assembly

Product Details

This InMotion wheel bearing and hub assembly is built for the rear position on the Toyota Sequoia and follows OE dimensions for fitment, performance, and durability. The WA512211 hub assembly uses application-specific measurements to match the original mounting points and wheel interface, making it a practical choice for rear hub service on 2001-2007 Toyota Sequoia Standard Grade models. If you are replacing a worn rear hub on a Toyota Sequoia, WA512211 provides the correct hub pilot diameter, bolt pattern, and flange geometry for the listed application.

Common Repair Uses

• Rear wheel bearing noise from a worn hub assembly
• Wheel play or looseness at the rear axle
• Uneven rear wheel rotation caused by hub wear
• Vibration or rumbling from the rear wheel area
• Replacement after hub seal or bearing deterioration

Installation Notes

Confirm rear-position fitment before installation and verify the hub pilot diameter, bolt circle diameter, and flange offset against the removed part. Because the ABS sensor is not included, reuse or service the vehicle’s existing sensor setup as required by the application. For best results, inspect related rear suspension and axle components during replacement and torque all fasteners to factory specifications.

Quality Assurance

InMotion manufactures this hub assembly using high-precision processes and strict quality-control criteria. The part is engineered from OE data and measurements to support correct fitment and consistent performance on the specified Toyota Sequoia applications. Part number WA512211 is built as a direct replacement hub assembly for the listed rear fitment.