InMotion WA512395 Wheel Bearing and Hub Assembly - Rear

Rear Wheel Hub Assembly for Volvo XC90

Restore rear wheel support and ABS signal performance with this InMotion wheel bearing and hub assembly for the Volvo XC90. Built as a direct replacement for the original rear hub, Part Number WA512395 is engineered from OE data to match the specified application and dimensions.

• Fits 2003-2014 Volvo XC90, rear
• Direct replacement wheel bearing and hub assembly
• ABS sensor included for rear wheel speed signal integration
• 5 wheel studs with 12.5 stud size
• 4 flange bolt holes for application-specific mounting
• OE-based fitment, performance, and longevity targets
• Part Number: WA512395

Application and Fitment Details

This rear hub assembly is built for the Volvo XC90 and matches the rear position specified in the fitment data. InMotion WA512395 is manufactured using high-precision processes and strict quality-control criteria, with dimensions that include a 109.5 bolt circle diameter, 135.7 flange diameter, 58.9 flange offset, 87.4 hub pilot diameter, 66.9 wheel pilot diameter, and 68.0 brake pilot diameter.

For buyers searching for a rear wheel bearing and hub assembly for 2003-2014 Volvo XC90, Part Number WA512395 provides a direct replacement format that aligns with OE measurements. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Problems This Part Can Address

• Rear wheel bearing noise such as humming, growling, or rumbling
• Excessive wheel play or looseness at the rear hub
• ABS warning light caused by a failed rear wheel speed sensor assembly
• Uneven rear wheel rotation from worn hub components
• Vibration or instability traced to hub wear on a Volvo XC90

Installation Notes and Tips

Confirm rear-position fitment before installation and verify all hub dimensions against the original part. Inspect the mounting surface, axle area, and brake components for wear or corrosion before installing the new assembly. Because the ABS sensor is included, ensure the electrical connector and tone-ring-related components are clean and properly seated during installation.

Quality Assurance

InMotion manufactures this hub assembly with OE data and measurements to support proper fitment, performance, and service life. Each unit is produced under strict quality-control criteria and built for the designated application.