InMotion WA512421 Wheel Bearing and Hub Assembly - Rear Left

Rear Left Wheel Hub for Toyota Venza

InMotion WA512421 is a rear left wheel bearing and hub assembly for the 2009-2016 Toyota Venza. Built as a direct replacement for the original hub assembly, it is engineered from OE data and measurements for accurate fitment, stable wheel support, and consistent service life.

• Fits 2009-2016 Toyota Venza, rear left
• Wheel bearing and hub assembly for driveline and axle service
• 5 wheel studs with a 4.5 in. bolt circle diameter (114.3 mm)
• ABS sensor included for vehicles equipped with wheel speed sensing at the hub
• Hub pilot diameter: 84.0 mm; wheel pilot diameter: 60.0 mm; brake pilot diameter: 62.0 mm
• Modified flange design with 4 flange bolt holes and 72.0 mm flange offset

OE-Style Fit and Dimensions

This InMotion wheel bearing and hub assembly WA512421 is manufactured with high-precision processes and strict quality-control standards. The hub is built to match the designated application for the Toyota Venza rear left position, using OE-based measurements to support proper wheel mounting, brake alignment, and hub-to-wheel interface dimensions. The 152.0 mm flange diameter and 84.0 mm hub pilot diameter help maintain the correct geometry for the vehicle’s rear suspension and wheel assembly.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Replacement Reasons

• Wheel bearing noise from the rear left side
• Excessive wheel play or looseness at the hub
• ABS warning light caused by a failing hub sensor or bearing assembly
• Uneven brake feel or vibration related to hub wear
• Corrosion or damage at the wheel mounting surface

Installation Notes

Confirm rear left fitment before installation on the 2009-2016 Toyota Venza. Verify bolt circle, pilot diameters, flange offset, and ABS sensor connection against the removed part before assembly. Clean the mounting surface, inspect related hardware and brake components, and torque fasteners to the vehicle manufacturer’s specifications.

Quality Assurance

InMotion manufactures this hub assembly using OE data and dimensional measurements to support proper fitment and long-term performance. The part number WA512421 is built for direct replacement use on the Toyota Venza rear left application.