InMotion WA512568 Wheel Bearing and Hub Assembly - Rear

Rear Wheel Bearing and Hub Assembly for Jeep Compass and Renegade

The InMotion WA512568 rear wheel bearing and hub assembly is built for direct replacement service on select Jeep and Fiat applications. Engineered from OE data and measurements, it is designed to match the original mounting and fitment requirements for a precise repair.

Compatible with 2017-2022 Jeep Compass rear, 2015-2018 Jeep Renegade rear, 2020-2021 Jeep Renegade rear, and 2016-2018 Fiat 500X rear, this assembly supports a clean OE-style installation on the rear axle. The integrated ABS sensor is included for vehicles that require wheel speed signal integration.

Key Features

• Part number: WA512568
• Rear wheel bearing and hub assembly
• Direct replacement design based on OE data and measurements
• Anti-lock brake sensor included
• 5 wheel studs
• 4 flange bolt holes
• Bolt circle diameter: 109.9
• Flange diameter: 135.1
• Flange offset: 41.9
• Wheel pilot diameter: 65.0
• Brake pilot diameter: 69.9
• Hub pilot diameter: 84.0

Detailed Description

InMotion manufactures this wheel bearing and hub assembly with high-precision processes and strict quality-control standards to maintain consistent dimensions and fit. The WA512568 is built for rear applications and is specified for Jeep Compass, Jeep Renegade, and Fiat 500X models listed in the fitment data. Its OE-based engineering helps ensure the hub, bearing, stud pattern, and sensor interface align with the original equipment layout.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What This Part Helps Address

• Rear wheel bearing noise or rough rotation
• Hub play or looseness at the wheel
• ABS warning light concerns related to the wheel speed sensor circuit
• Uneven wheel mounting caused by worn hub components
• Restoration of proper rear wheel support on Jeep Compass, Jeep Renegade, and Fiat 500X models

Installation Notes and Tips

Confirm rear fitment by year, make, and model before installation. Verify the bolt circle diameter, stud count, and pilot dimensions against the original part to ensure correct match-up. Inspect the mounting surface, axle area, and related brake components for wear before installing the new hub assembly. If the vehicle uses an ABS system, check the sensor connection and wiring condition during replacement.

Quality Assurance

InMotion builds this hub assembly using OE data, precise measurements, and controlled manufacturing processes to support consistent fit and long-term service performance. The WA512568 is produced as a direct replacement part for the listed rear applications.

• Fits 2017-2022 Jeep Compass, rear
• Fits 2015-2018 Jeep Renegade, rear
• Fits 2020-2021 Jeep Renegade, rear
• Fits 2016-2018 Fiat 500X, rear