InMotion WA513090 Wheel Bearing and Hub Assembly - Front or Rear

Wheel Bearing Hub Assembly for Camaro, Firebird, and S10

The InMotion WA513090 wheel bearing and hub assembly is built as a direct replacement for select Chevrolet and Pontiac applications. It is engineered from OE data and measurements for accurate fitment, stable wheel support, and consistent service life.

Key Features

• Direct replacement wheel bearing and hub assembly
• High-precision manufacturing with strict quality-control standards
• 5 wheel studs with a 4-bolt flange design
• ABS sensor included
• Wheel pilot diameter: 70.1 mm
• Brake pilot diameter: 70.6 mm
• Hub pilot diameter: 71.7 mm
• Bolt circle diameter: 120.7 mm / 4.75 in.
• Flange diameter: 146.5 mm with 69.0 mm offset

Detailed Description

InMotion WA513090 is a front or rear wheel bearing hub assembly depending on application, designed for 1993-2002 Chevrolet Camaro front, 1993-2002 Pontiac Firebird front, and 1997-1998 Chevrolet S10 rear. This part number is built to match OE dimensions and mounting points, helping maintain proper wheel location, bearing support, and ABS system function where equipped. If you are replacing a worn hub on a Chevrolet Camaro, Pontiac Firebird, or Chevrolet S10, WA513090 provides the dimensional accuracy needed for a clean service replacement.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Problems This Part Can Address

• Wheel bearing noise or growling from the hub area
• Excessive wheel play or looseness at the hub
• ABS warning light caused by a failed hub sensor assembly
• Uneven wheel support from a worn front or rear hub
• Vibration or instability related to hub wear

Installation Notes and Tips

• Verify position before ordering: Fits 1993-2002 Chevrolet Camaro, front; Fits 1993-2002 Pontiac Firebird, front; Fits 1997-1998 Chevrolet S10, rear.
• Confirm bolt circle, pilot diameters, and stud count against the original hub before installation.
• Inspect the knuckle, axle, and mounting surfaces for wear or damage before pressing or bolting in the new assembly.
• After installation, check ABS operation and verify proper wheel torque to manufacturer specifications.

Quality Assurance

Each InMotion WA513090 hub assembly is manufactured using OE data and measurements and produced under strict quality-control criteria for fitment, performance, and longevity. The design is application-specific for the listed Chevrolet Camaro, Pontiac Firebird, and Chevrolet S10 fitments.