InMotion WA513221 Wheel Bearing and Hub Assembly - Front

Front Wheel Bearing Hub Assembly for Mustang

InMotion WA513221 is a front wheel bearing and hub assembly for 2005-2014 Ford Mustang Standard Grade applications. Built from OE data and measurements, it is engineered for direct replacement fitment, stable wheel support, and consistent hub performance on the front axle.

Key Features

• Fits 2005-2014 Ford Mustang, front
• Wheel bearing and hub assembly for driveline and axle service
• Anti-lock brake sensor included
• 5 wheel studs with a 114.3 mm bolt circle diameter
• Wheel pilot diameter: 70.5 mm
• Brake pilot diameter: 71.0 mm
• Hub pilot diameter: 102.0 mm
• Flange diameter: 147.7 mm
• OE-data-based design for application-specific fitment

Detailed Description

InMotion WA513221 is a front hub assembly designed for Ford Mustang models from 2005 through 2014. The assembly is manufactured with tight dimensional control and built to match the original application using OE measurements, helping maintain proper wheel location, brake interface alignment, and sensor integration. For buyers searching for a Ford Mustang front wheel bearing hub assembly or a direct replacement hub for 2005-2014 Mustang front service, WA513221 provides the specified pilot diameters, stud count, and bolt pattern needed for the listed application.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Repair Uses

• Wheel bearing noise from the front hub area
• Excessive play or looseness at the front wheel
• ABS warning light related to hub sensor function
• Uneven wheel mounting or hub-to-wheel fit concerns
• Front-end vibration traced to hub wear

Installation Notes and Tips

Confirm the vehicle is a 2005-2014 Ford Mustang, front application before ordering. Verify the wheel pilot, brake pilot, hub pilot, bolt circle diameter, and 5-stud configuration against the original part. Because the ABS sensor is included, inspect the connector and harness condition during installation and clear any stored fault codes after service.

Quality Assurance

InMotion manufactures this hub assembly using high-precision processes and strict quality-control criteria. Each unit is engineered from OE data and measurements to support proper fitment, performance, and service life in the specified Mustang front application.