InMotion WA515081 Wheel Bearing and Hub Assembly - Front

Front Wheel Hub Assembly for Super Duty Trucks

InMotion WA515081 is a front wheel bearing and hub assembly built for 2005-2010 Ford F-250 Super Duty and 2005-2010 Ford F-350 Super Duty applications. It is engineered from OE data and measurements for direct replacement fitment, with precision manufacturing and quality control focused on fit, performance, and service life.

Key Features

• Direct replacement front hub assembly for Ford F-250 Super Duty and Ford F-350 Super Duty
• Part number WA515081
• 32-spline design
• 8 wheel studs
• 4 flange bolt holes with square flange shape
• ABS sensor included
• Flange offset: 46.5 mm
• Bolt circle diameter: 170.0 mm (6.693 in.)
• Wheel pilot diameter: 125.0 mm
• Brake pilot diameter: 129.1 mm
• Hub pilot diameter: 140.0 mm

Detailed Description

InMotion WA515081 is a wheel bearing and hub assembly designed for the front axle of 2005-2010 Ford F-250 Super Duty and 2005-2010 Ford F-350 Super Duty trucks. Built using OE reference data, it is shaped to match the original mounting points and critical dimensions needed for proper wheel location, brake alignment, and ABS system integration. This part cross-references AC3Z1104F and HUB158 for the same application.

For buyers searching for a front wheel hub assembly for Ford F-250 Super Duty, a Ford F-350 Super Duty front hub replacement, or WA515081 wheel bearing hub assembly fitment, this unit provides the key specifications needed for a direct replacement service part.

What It Helps Address

• Wheel bearing noise from a worn front hub assembly
• Excessive wheel play or looseness at the front axle
• ABS warning light concerns related to a failed hub sensor assembly
• Uneven brake rotor alignment caused by hub wear
• Front-end vibration traced to hub or bearing deterioration

Installation Notes and Tips

Confirm the vehicle is a 2005-2010 Ford F-250 Super Duty or 2005-2010 Ford F-350 Super Duty, front position, before ordering. Verify spline count, bolt circle diameter, flange offset, and sensor configuration against the original part. Clean the mounting surface thoroughly and inspect related components such as the axle shaft, knuckle, and brake hardware during replacement.

Quality Assurance

InMotion manufactures this hub assembly with strict quality-control criteria and OE-based measurements to support consistent fitment and long-term service. The WA515081 is produced as a direct replacement part for the listed Ford Super Duty front applications.