InMotion WDS36-900 Drive Shaft - Rear

Rear Drive Shaft for Subaru Legacy, Outback, and Baja

The InMotion WDS36-900 is a rear drive shaft built for specific Subaru applications that use a middle CV joint conversion to a U-joint. It is a direct driveline replacement for select Subaru Legacy, Outback, and Baja models, with fitment covering 1996-2006 vehicles depending on model.

Key Features

• Rear drive shaft for driveline and axle service
• Fits 2003-2006 Subaru Baja, rear, middle CV joint conversion to U-joint
• Fits 2001-2004 Subaru Outback, rear, middle CV joint conversion to U-joint
• Fits 1996-1999 Subaru Legacy, rear, middle CV joint conversion to U-joint
• Shaft material: 45,40Cr?SS400
• Slip yoke included in the shaft design
• Drive shaft length: 62.402 in. (1585 mm)
• Shaft diameter: 63 mm
• Wall thickness: 2 mm

Detailed Description

InMotion WDS36-900 is a rear drive shaft engineered for Subaru driveline repair where the original middle CV joint has been converted to a U-joint. This part number is listed for 2003-2006 Subaru Baja, 2001-2004 Subaru Outback, and 1996-1999 Subaru Legacy rear applications. The shaft measures 62.402 inches long, with a 63 mm diameter and 2 mm wall thickness, and it uses a slip yoke design. CV joints and axle nut are not included.

This part cross-references Dorman OE Solutions 936-900 for the same application. The InMotion WDS36-900 is a practical replacement choice when servicing Subaru Legacy, Outback, or Baja rear driveline assemblies that require the specified conversion setup.

Common Problems This Part Addresses

• Excessive vibration from a worn rear drive shaft
• Driveline noise caused by damaged shaft components
• Failure of the original rear shaft in converted CV-to-U-joint setups
• Loss of smooth power transfer through the rear driveline
• Need for a direct replacement during Subaru driveline repair

Installation Notes and Tips

Verify rear fitment by year, model, and conversion type before installation. Confirm the shaft length, diameter, and slip yoke configuration match the original assembly. Because CV joints and axle nut are not included, reuse or source any additional components required by the vehicle setup. Professional installation is recommended for driveline alignment and proper torque procedures.

Quality Assurance

Built to the listed dimensional and material specifications for the stated Subaru applications, the InMotion WDS36-900 supports accurate replacement selection for rear driveline service.