InMotion WLK432 Suspension Knuckle Assembly - Front Right

Front Right Suspension Knuckle Assembly

InMotion WLK432 is a front right suspension knuckle assembly for select Toyota Highlander and Lexus RX applications. It arrives with the major wheel-end components already assembled, helping reduce the time and equipment normally needed for knuckle and wheel bearing service.

• Front right suspension knuckle assembly
• Pre-assembled wheel-end service part for faster replacement
• Eliminates the need to press individual bearing components during installation
• Common hand tools can be used for the swap
• Part number: WLK432

Vehicle Fitment

• Fits 2008-2017 Toyota Highlander, front right. Contains snap ring, knuckle, wheel hub, bearing, axle nut, and dust shield.
• Fits 2010-2015 Lexus RX350, front right. Contains snap ring, knuckle, wheel hub, bearing, axle nut, and dust shield.
• Fits 2010-2015 Lexus RX450h, front right. Contains snap ring, knuckle, wheel hub, bearing, axle nut, and dust shield.

How It Helps

• Replaces a worn or damaged front right knuckle on a Toyota Highlander
• Addresses wheel bearing noise or rough rotation at the front right corner
• Helps restore proper wheel support and steering knuckle function on Lexus RX350 and RX450h models
• Reduces the risk of damage that can occur when pressing bearings in and out separately
• Speeds up service when replacing the knuckle and hub assembly together

Installation Notes

Remove the original front right knuckle assembly and bolt the replacement unit in place. This WLK432 assembly is built for direct replacement and can be installed with common hand tools. Verify year, model, and front right position before ordering.

Quality Assurance

InMotion WLK432 is supplied as a complete steering knuckle assembly with the wheel hub and bearing already installed for the listed applications. This format supports consistent service results by reducing separate component handling during repair.