InMotion WS413248 Wheel Seal - Front Inner, Front Outer or Rear Outer

Wheel Seal for Differential Pinion Applications

The InMotion WS413248 wheel seal is built with nitrile material to create a dependable sealing surface around the shaft and housing bore. It helps keep moisture and road debris out of the differential pinion area while supporting leak control in front inner axle locations.

• Nitrile construction for sealing performance in driveline service
• Inside diameter: 2.625 in.
• Outside diameter: 3.376 in.
• Width: 0.375 in.
• Shaft diameter: 2.625 in.
• Housing bore: 3.371 in.

Fitment Details

• Fits 1980-1985 Dodge Ramcharger, front inner, without locking hubs
• Fits 1980-1985 Dodge W150, front inner, without locking hubs
• Fits 1981-1985 Dodge W250, front inner, with Spicer 44F-BJ axle
• Fits 1975-1980 Dodge W200, front inner, with Spicer 44F-BJ axle
• Fits 1975-1979 Dodge Ramcharger, front inner
• Fits 1977-1979 Dodge W150, front inner
• Fits 1976-1977 Dodge W100, front inner
• Fits 1975 Dodge W100, front outer

How This Seal Is Used

Use this seal when servicing the differential pinion area on compatible Dodge front axle applications. It is a direct-fit sealing component for restoring barrier protection where the pinion shaft passes through the housing.

• Stops gear oil seepage at the pinion seal area
• Helps block dirt and moisture from entering the differential
• Supports repair of worn or hardened original seals
• Addresses contamination concerns in front axle service
• Helps maintain proper sealing on Dodge W100, W150, W200, W250, and Ramcharger applications

Installation Notes and Tips

Confirm shaft diameter and housing bore before installation. Clean the sealing surface thoroughly, inspect the pinion area for wear, and install the seal squarely to avoid distortion. For best results, verify axle configuration, including locking hub status and Spicer 44F-BJ axle notes where listed. Part number WS413248 should be matched to the exact vehicle and position before assembly.

Quality Assurance

InMotion manufactures this seal with precision-focused dimensions and nitrile material selected for driveline sealing service. Part number WS413248 is specified for the listed Dodge front inner and front outer applications, including Dodge Ramcharger and Dodge W-series trucks. This part cross-references Monroe Shocks & Struts (e.g., 172286) for the same application.