InMotion WS470059 Manual Transmission Remote Control Seal - Rear or Rear Outer

Manual Transmission Seal for Classic Ford and Jeep Applications

Restore sealing performance in older manual transmission setups with the InMotion WS470059 seal. Built with nitrile sealing material and precise dimensions, it helps maintain a tight barrier at the shaft and housing interface to keep contaminants out and fluid where it belongs.

Compatible With classic Ford F-100, F-250, F-350, Mustang, Thunderbird, and Jeep CJ5, CJ7, Wagoneer, and Cherokee applications listed below, this seal is sized for specific Borg-Warner and Ford transmission configurations. The InMotion WS470059 is a direct-fit service part for many vintage driveline repairs.

Key Features

• Nitrile sealing material for dependable resistance to transmission fluids
• Inside diameter: 1.5 in.; shaft diameter: 1.5 in.
• Outside diameter: 2.378 in.; housing bore: 2.374 in.
• Thickness and width: 0.5 in.
• Designed for manual transmission remote control seal applications
• Part number WS470059 for accurate ordering and service matching

Detailed Description

The InMotion WS470059 is a precision-manufactured manual transmission remote control seal built from nitrile for consistent sealing performance. Its measured dimensions are matched to the shaft and housing bore requirements shown in the product data, helping create a secure seal against moisture, dirt, and other contaminants that can affect internal transmission components. This part number, WS470059, is listed across a wide range of classic Ford and Jeep manual transmission applications, including T18, T15A, T14A, T85, T86, and related Borg-Warner and Ford 2.77 configurations. It is also listed for select rear applications on Oldsmobile, Pontiac, and Cadillac models.

This part cross-references no additional part numbers in the provided data.

What It Helps Address

• Transmission fluid seepage at the seal interface
• Contamination from road debris and moisture
• Wear-related sealing loss in older manual transmission assemblies
• Service issues during restoration or driveline maintenance
• Seal replacement needs on vintage Ford and Jeep vehicles

Installation Notes and Tips

• Verify the transmission code and application before installation, especially on Ford and Jeep models with multiple gearbox variants.
• Confirm shaft diameter, housing bore, and seal width against the removed part.
• Inspect the sealing surface for scoring or corrosion before installing the new seal.
• Use clean assembly practices to avoid damaging the nitrile lip during installation.
• Match the application exactly for vehicles such as Ford F-100, F-250, F-350, Mustang, and Jeep CJ5/CJ7 listed in the fitment data.

Quality Assurance

InMotion manufactures this seal with precision sizing and nitrile construction for service use in classic driveline applications. The WS470059 is specified for confirmed fitments across 1953-1979 Ford, Jeep, Mercury, Oldsmobile, Pontiac, and Cadillac vehicles listed in the product data.