InMotion WS5796 Wheel Seal - Front Inner

Wheel Seal for Differential Pinion Service

The InMotion WS5796 wheel seal is built for differential pinion sealing applications where a precise barrier against dirt, moisture, and lubricant loss matters. With a 1.562 in inside diameter, 2.69 in outside diameter, and 0.375 in width, it is sized for accurate housing and shaft engagement in the intended driveline assembly.

For technicians servicing axle and driveline components on vehicles such as the Honda Civic or Toyota Corolla, the WS5796 provides a direct-fit sealing solution when the original seal shows wear, leakage, or contamination damage.

Key Features

• Leather sealing material for dependable contact at the shaft interface
• Inside diameter: 1.562 in
• Outside diameter: 2.69 in
• Width: 0.375 in
• Shaft diameter: 1.562 in
• Housing bore: 2.686 in
• Designed to help maintain a clean, sealed differential pinion area

Detailed Description

InMotion WS5796 is a driveline sealing component engineered to help protect sensitive internal differential parts from debris and moisture intrusion. Its measured dimensions support a secure fit at the pinion area, helping reduce lubricant seepage and preserving the operating condition of the differential assembly. This makes the WS5796 a practical choice for routine axle seal replacement on passenger cars and light-duty applications where seal integrity is critical.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What It Helps Address

• Gear oil seepage at the differential pinion seal area
• Contamination entering the differential housing
• Seal wear from age, heat, and road exposure
• Loss of sealing performance after driveline service
• Noise or driveline concerns related to lubricant loss

Installation Notes and Tips

Inspect the pinion shaft, housing bore, and surrounding surfaces before installation. Remove all old seal material, clean the bore thoroughly, and verify the dimensions match the application before pressing the new seal into place. Proper alignment during installation helps prevent premature wear and leakage. Confirm vehicle-specific service procedures for the Honda Civic, Toyota Corolla, or other listed application before reassembly.

Quality Assurance

InMotion manufactures this seal with precision-focused construction and material selection intended for reliable driveline sealing performance. The WS5796 is built to support consistent fitment and long-term service in the differential pinion location.