InMotion WS710079 Wheel Seal - Rear Inner

Wheel Seal for Differential Pinion Service

The InMotion WS710079 wheel seal is built for differential pinion sealing applications where keeping lubricant in and contaminants out matters. Made from nitrile and sized for a 3.189 in shaft diameter with a 4.921 in housing bore, it provides a precise sealing interface for driveline service.

Use this seal when servicing a differential pinion on vehicles such as Honda Civic or Toyota Corolla applications that require accurate seal dimensions and dependable fluid control. The WS710079 is engineered to help maintain internal cleanliness and reduce leakage at the pinion area.

Key Features

• Nitrile construction for sealing performance in driveline environments
• Inside diameter: 3.189 in
• Shaft diameter: 3.189 in
• Outside diameter: 4.929 in
• Housing bore: 4.921 in
• Width: 0.433 in
• Designed for differential pinion sealing service
• Part number: WS710079

Detailed Description

InMotion WS710079 is a precision seal intended for the differential pinion area, where dimensional accuracy is critical to controlling gear oil and limiting contamination. The nitrile sealing material is selected for its practical use in automotive sealing systems, and the listed dimensions help technicians verify fit against the shaft and housing before installation. For buyers searching for a differential pinion seal, wheel seal, or driveline gasket and sealing system component, this part number provides a direct reference for service matching. It is a relevant choice for Honda Civic and Toyota Corolla repair work when the required measurements align with the application.

What It Helps Address

• Gear oil seepage at the differential pinion seal area
• Contamination entering the differential housing
• Wear caused by degraded or hardened sealing material
• Loss of sealing integrity during driveline service
• Fitment issues when replacing a seal by dimension

Installation Notes and Tips

Confirm shaft diameter, housing bore, outside diameter, and width before installation. Clean the sealing surface thoroughly, inspect the pinion area for scoring or wear, and verify that the replacement seal seats squarely in the bore. Use the vehicle service procedure for the specific axle or differential assembly, and compare the old seal to WS710079 before final assembly.

Quality Assurance

InMotion manufactures this seal with precision-focused dimensions and nitrile material selection to support reliable differential sealing performance. Part number WS710079 is specified for accurate identification during driveline and axle service.