InMotion WS710463 Wheel Seal - Front Outer or Rear Inner

Wheel Seal for Subaru and Saab Front Outer Applications

The InMotion WS710463 wheel seal is built with nitrile material to help maintain a secure barrier at the front outer position. It is engineered to keep contaminants out and help reduce fluid leakage around the differential pinion area, supporting long-term driveline protection.

Compatible With 1990-2008 Subaru Legacy, Subaru Outback, Subaru Forester, Subaru Impreza, Subaru Baja, and 2005-2006 Saab 9-2X front outer applications. Part number WS710463 is sized with a 2.205 in inside diameter, 2.854 in outside diameter, 0.315 in width, and a 2.846 in housing bore.

Key Features

• Nitrile seal material for dependable sealing performance
• Inside diameter: 2.205 in
• Outside diameter: 2.854 in
• Width: 0.315 in
• Housing bore: 2.846 in
• Shaft diameter: 2.205 in
• Front outer position fitment

Detailed Description

InMotion WS710463 is a front outer wheel seal for select Subaru and Saab vehicles, including Subaru Forester, Subaru Impreza, Subaru Baja, Subaru Legacy, Subaru Outback, and Saab 9-2X applications. Its nitrile construction is selected for sealing durability and resistance to contamination, helping protect sensitive internal differential pinion components from moisture and debris. For drivers maintaining driveline integrity on daily-driven vehicles or vehicles used in harsher conditions, this seal supports a tight fit at the specified dimensions.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application. Use part number WS710463 when verifying the correct front outer seal for your vehicle.

What It Helps Address

• Gear oil seepage at the front outer seal area
• Contamination entering the differential pinion region
• Wear caused by moisture and road debris exposure
• Seal deterioration from age and mileage
• Loss of sealing integrity during driveline service

Installation Notes and Tips

Confirm the front outer position and compare the seal dimensions before installation. Inspect the shaft and housing surfaces for scoring, corrosion, or debris that could affect sealing. Clean the mating area thoroughly and verify that the seal seats evenly to the specified housing bore and shaft diameter.

Quality Assurance

InMotion manufactures this seal with precision-focused dimensions and nitrile material selection to support consistent sealing performance in the specified applications. Verify fitment by year, make, model, and position before installation.