InMotion WS710477 Wheel Seal - Front or Front Outer

Front Outer Wheel Seal for Toyota and Lexus

Restore sealing performance at the front axle with the InMotion WS710477 wheel seal. Built from nitrile and sized for a precise fit, this seal helps keep moisture and road debris out of the differential pinion area while supporting leak control in demanding driving conditions.

• Nitrile construction for dependable sealing performance
• Inside diameter: 3.189 in.
• Outside diameter: 3.809 in.
• Width: 0.63 in.
• Shaft diameter: 3.189 in.
• Housing bore: 3.801 in.
• Front outer and front position coverage for select Toyota and Lexus applications

Fitment Coverage

• Fits 2020-2023 Lexus GX460, Front Outer
• Fits 2011-2017 Lexus GX460, Front Outer
• Fits 2018-2023 Toyota 4Runner, Front
• Fits 2020-2023 Toyota Tacoma, Front
• Fits 2018 Toyota Tacoma, Front
• Fits 2005-2015 Toyota Tacoma, Front
• Fits 2019 Toyota Tacoma, Front Outer
• Fits 2016-2017 Toyota Tacoma, Front Outer
• Fits 2003-2017 Toyota 4Runner, Front
• Fits 2007-2014 Toyota FJ Cruiser, Front
• Fits 2003-2009 Lexus GX470, Front Outer

How This Seal Helps

The InMotion WS710477 is used in front axle sealing applications where the differential pinion area needs protection from contamination and fluid loss. On Toyota Tacoma, Toyota 4Runner, Toyota FJ Cruiser, Lexus GX460, and Lexus GX470 platforms, a worn seal can lead to gear oil seepage, contamination intrusion, and accelerated wear. This seal addresses those issues by maintaining a tight barrier at the specified shaft and housing dimensions.

• Helps stop differential pinion oil leaks
• Helps block dirt, water, and debris from entering the sealed area
• Helps reduce wear caused by contaminated lubricant
• Helps maintain proper sealing at the front axle interface
• Supports service repair on high-mileage Toyota and Lexus driveline systems

Installation Notes and Tips

Verify shaft diameter, housing bore, and seal width before installation. Clean the sealing surface thoroughly, inspect the mating components for scoring or corrosion, and install the seal squarely to avoid distortion. For best results, replace a damaged seal during axle or differential service rather than reusing a worn component.

Quality Assurance

InMotion manufactures this seal with precision-focused dimensions and nitrile material selection to support consistent sealing performance in driveline service. Part number WS710477 is identified for the listed Toyota and Lexus front axle applications.